How To Series | How to use your control panel in depth
HTML-код
- Опубликовано: 31 окт 2018
- Welcome to our "How To" Aquaterra video series!
On this video, you will learn how to master your control panel and learn more in depth how to navigate your hot tub's modes.
If you have any questions, please contact us at ahsservice@watkinsmfg.com or 888-961-7727. 
Кино
![Jordan Adetunji - KEHLANI REMIX (feat. Kehlani) [Official Video]](http://i.ytimg.com/vi/EeJ8n5PxFGE/mqdefault.jpg)
What is ep?
When we get to ST and push the light button EP0 then push the light button again F comes up push it again and the temperature appears. What is EP0 mean and are we doing something wrong?
I attempted to set up the mode and now keep getting a or6F code and the water does not heat above 85
My outdoor temperature is about 55 degrees. What mode is the best mode to keep it at 98 degrees. ST, EC or night time?
I just set up the ls100 and the jets are never fully on, they pulse...so they are off for ten seconds then theres a burst of jet then its idle again..then it bursts again. Im not sure if this is normal and if not i have no idea how to fix it. Its brand new!
Which code represents STANDARD.....?????
What does it mean if you hold down the light button to set filtration and F1 doesn't appear?
How do I set the clock time?
I held the heat button till or5 was displayed. If I hit the plus button it went to or6. What do these codes mean? I was trying to override the heat so it goes 1 to 2 degrees over 104.
You did what you wanted. Or5 will go to 105; or6 to 106 degrees.
What happens when it displays everything but still works?? New controller?
What is meant by 4 8's below the 5 symbols
How long does it take to heat up? I’ve had it heating for like 4-5 hours and it’s still 76* degrees. 😩
I calculated about 2.4 degrees per hour when plugged into a 110V AC outlet.
@@josephpankow2214 This is good information that I will add to for anyone doing research on this topic. I have a 2014 Transport II from Costco and I only have used the 230V AC configuration and I get 3 Degrees every 30 minutes after 8 years of use and Ohio Winters (its 2022) I'm still pretty impressed with the aquaterra brand. I had to get into tighten the seal on the heat tube this year to stop a leak but we are still enjoying it.
I had the tub installed on 203V. The crappy owner's manual says After powering up....press and hold the Jets button for 30 seconds to get to reconfigure the firmware from LL1 to LL2. This doesn't happen. WTF is wrong with people?
Neither of your control panel operation videos show the control panel on my Navarro spa. After F1 and F2 it goes straight to EP, and then I can only select 0 or 1.
I can't get to St, Ec, or Sl mode choices. Your directions in the manual AND on your videos are FUBAR and fail to cover my model. What gives?