Thanks for an excellent, clear video. I've been shopping for pocket door handles and I couldn't see how the bit would work to pull the door open. You showed clearly how you push in and the latch pops out. Finally!
Just a tip, i typically put the bottom gliders behind the finish trim. So you dont see them and dont have to cut them off. So, install them during rough in, after the door is mounted. And before you install the finish trims (1x2).
Install the original bottom guides at almost a 45 degree angle near the bottom edge of the door. Sort of like this \ / this way you can make good contact with both sides of the bottom edge that will remove all of the wiggle out. You're welcome 😊
Hi there, I currently have a door with a pre-drilled hole that is 2 inches in diameter and 1& 1/2 inches away from the door's edge. Can you advise if this lock will work with this hole? Thanks a mil!
Hi there, I have a door with a pre-drilled hole that is 2 inches in diameter and approximately 1 & 1/2 inches from the door's edge. Can you say if this lock will work with these dimensions? Thanks a mil for your help!
😎If you like this video please SUBSCRIBE! and check out my other similar videos!👍
ruclips.net/user/borsellinocarpentry
Thanks for an excellent, clear video. I've been shopping for pocket door handles and I couldn't see how the bit would work to pull the door open. You showed clearly how you push in and the latch pops out. Finally!
Same question I had.
Thanks was wondering how to grab the edge of the door. You showed that flip out part on the latch. Good explanation.
Great Video! Thanks for posting.
Just a tip, i typically put the bottom gliders behind the finish trim. So you dont see them and dont have to cut them off. So, install them during rough in, after the door is mounted. And before you install the finish trims (1x2).
oh interesting. But what if you have to make any adjustments?!
Install the original bottom guides at almost a 45 degree angle near the bottom edge of the door. Sort of like this \ / this way you can make good contact with both sides of the bottom edge that will remove all of the wiggle out. You're welcome 😊
Good tip!
Thanks.
Hi there, I currently have a door with a pre-drilled hole that is 2 inches in diameter and 1& 1/2 inches away from the door's edge. Can you advise if this lock will work with this hole? Thanks a mil!
it should! If you get it from amazon you could always return it if it doesn't fit
Hi there, I have a door with a pre-drilled hole that is 2 inches in diameter and approximately 1 & 1/2 inches from the door's edge. Can you say if this lock will work with these dimensions? Thanks a mil for your help!
no
ok, thanks for the feedback
@@martinluthierking
How has that flip out lever held up?
I don't know I installed this at a customer's house
Where do you buy this? Thanks so much
there's links to purchase in the video description :)
Mine wont activate the lock