Hi everyone, one question if anybody knows? My 645CI SMG after it gets warm, at a stop gets confused and falls out of gear and won't go back in 1st but only switches between 1st and 2nd gear and it also won't go in the R. After 20 min or so it's all back to normal. I've changed shift sensor and selection sensor because my car would't go in 2nd, 4th and 6th gear. That's when I started having problems with my smg, but after that this temperature problem occurred. Is it because the hydraulic unit can't hold pressure? The Clutch position sensor or actuator slave cylinder? Leak somewhere? Adaptation on a cold trans? Help please.
hi happen to me also, i just disconnect the battery both cables leave it for 10 minutes after reconnection back the battery, and your transmission back to normal
Hello, by any chance you know a part number or a link to a website to get an input speed sensor for a BMW 750I 2009. plan to do some DIY on the transmission but i recently got an error about " Transmission Fault Code: 400626 - Turbine speed sensor short circuit to ground or open circuit"
My car BMW E90 320 i,has the same problem of displaying that gearbox warning light about 40 seconds and my really stress up.. can i be worried and how can i get help?
Got this message twice in 2 months but nothing happens and it runs fine, I'm taking it to BMW service center and seeing what they say. its a BMW 2006 m6
If the transmission fault stays on, Use your car scanner to erase all the code, than turn the car off than startit up again , it will take the transmission fault off.
Okay , everyone , here is how you do a quick fix with the Transmission issue. This happens to me all the time. Bummer most of the time going 75mpg on the freeway and this transmission issue comes up. Here is the fast fix not permanent. Pull to the side of the road as quick as you can. Turn your hazards on. Put the car in park. Turn off the motor. While the motor is off. Put your foot all the way down on the gas pedal NOT the break pedal. While your foot has the gas pedal all the way to the floor turn the key on all the way to start keep it there don't move your foot or the key leave it all the way on for 90 seconds , its going to seem like a long long time. Once 90 seconds is up. Turn the key in the off position and then start your car and go. Good luck
No hej. W moim wypadku spadek ciśnienia w pojemniku z olejem do skrzyni.Możliwe, że pęknięty jest Mechatronic Seal Adapter (nie wiem jak po polsku się ta część nazywa). Mechanik powiedział, że to bardzo częsta usterka. Możliwe tez, że masz za mało oleju w skrzyni. Proponuje sprawdzić u mechanika pod tym kątem.
Doug Quaid I tried to start my car, it was cracking but not starting, then I got the transmission fluid pop. I turned it off then started it , it started properly and the signal disappeared, could it be a battery drain ?
Hey i did service on my 2008 bmw 750li nd i disconnected the battery as soon i connect the battery nd started the car it gave me the warning of faulty transmission drive motherly
TRANSMISSION FAULT , EASY FIX....IST....CLOSE THE DOOR PUT SEAT BELT ON...2ND....TURN KEY TOO #2.....3RD...HOLD GAS PEDDLE DOWN , YOU WILL HEAR A CLICK, HOLD DOWN AND COUNT TOO 43..THEN TURN KEY OFF, THEN TURN CAR ON THEN TRANSMISSION FAULT GONE......
![I.N "HALLUCINATION" | [Stray Kids : SKZ-PLAYER]](http://i.ytimg.com/vi/n5B5q1Hwt_U/mqdefault.jpg)
Hi everyone, one question if anybody knows? My 645CI SMG after it gets warm, at a stop gets confused and falls out of gear and won't go back in 1st but only switches between 1st and 2nd gear and it also won't go in the R. After 20 min or so it's all back to normal. I've changed shift sensor and selection sensor because my car would't go in 2nd, 4th and 6th gear. That's when I started having problems with my smg, but after that this temperature problem occurred. Is it because the hydraulic unit can't hold pressure? The Clutch position sensor or actuator slave cylinder? Leak somewhere? Adaptation on a cold trans? Help please.
hi happen to me also, i just disconnect the battery both cables leave it for 10 minutes after reconnection back the battery, and your transmission back to normal
I have the same issue in my 645ci convertible.. Is the Crankshaft sensor.. Need yo remplace it
might be a transmission fluid leak, that is a pretty serious problem of not adressed timely
Did you change transmission oil ?
i did nd now doesnt work :(
Witaj. wiem ze minelo pare lat. ale czy ten blad wyskakiwal ci przy kicdown? na jaki okres czasu pomogla ci wymiana tego adaptera ? Pozdrawiam
If yellow dash light (no service engine) could just be fluid if stuck in gear or more likely whole computer unit for transmission?
Thank you for the tip, my car doesn’t have a check engine light and drives just doesn’t go past a certain gear. And shows the trans fault
@@topnotchbassin269 same here. Have you fixed the issue?
@@shiftautomotive854 did you fix the issue please help me
@@Baser999 had to replace the whole transmission after that it didn't come on
@@Baser999 most likely ur transmission fuck
Pressure in the "JEER Box" lollll🤣🤣🤣
💀
🤣🤣😂
🤣🤣😂😂😂
Hahahaha Jeer Box
Hi, I would like to know if the problem fixed at that time that video was taken or did you go to a mechanic/master to have it repaired?
Any idea on what small plastic part anyone??
i think its the seal like when u change the transmission fluid there is this one tehre that mustr be changed
So what was the problem????
I got a F481 on my 550i is that low transmission fluid?
What was the problem bro? I got the same code
Hello,
by any chance you know a part number or a link to a website to get an input speed sensor for a BMW 750I 2009. plan to do some DIY on the transmission but i recently got an error about " Transmission Fault Code: 400626 - Turbine speed sensor short circuit to ground or
open circuit"
My car BMW E90 320 i,has the same problem of displaying that gearbox warning light about 40 seconds and my really stress up.. can i be worried and how can i get help?
Did u fix the problem
Got this message twice in 2 months but nothing happens and it runs fine, I'm taking it to BMW service center and seeing what they say. its a BMW 2006 m6
Hi mate, what is that plastic part, where it’s, how looks like? I have the same problem now with my 525d. Thanks.
Mechatronic Seal Adapter - This is that "plastic part" i was talking about ;) Easily to google it
2. Error codes screen: imgur.com/fKgGRk0
Amigo dónde yeva ese plástico si saves
what plastic part did you replace?
Crank Shaft position sensor
Hello my 630i is also showing same problem kindly assist me how can I fix this problem.
Thank you
Syed Aqeel did you fix your car?
Jano Kokot it last “the life of the transmission” witch is x amount of kms lol
Where is the plastic part ?
Could be a battery issue, you had lots of errors there. Man some people need to grow up his accent is not his fault. He meant gearbox we all know that
Mate no it’s your battery
Hello Can you please help I have two codes 5089 and 5087 and my gear shifter is stuck in park mode it does not move to any other mode?
puneet kumar Sharma check the gioystick
I have same problem how did u come right to fix it plz stuck on park
Did this ever get fixed, I have the same issue
I got the same problem
If the transmission fault stays on, Use your car scanner to erase all the code, than turn the car off than startit up again , it will take the transmission fault off.
but will it fix the issue?
No
Wth is the plastic part you mean?
Sounds lile a JEERBOX problem to me
Check the jeer box or the jeer engine at gargosh
What little plasitc piece did you change
Okay , everyone , here is how you do a quick fix with the Transmission issue. This happens to me all the time. Bummer most of the time going 75mpg on the freeway and this transmission issue comes up. Here is the fast fix not permanent. Pull to the side of the road as quick as you can. Turn your hazards on. Put the car in park. Turn off the motor. While the motor is off. Put your foot all the way down on the gas pedal NOT the break pedal. While your foot has the gas pedal all the way to the floor turn the key on all the way to start keep it there don't move your foot or the key leave it all the way on for 90 seconds , its going to seem like a long long time. Once 90 seconds is up. Turn the key in the off position and then start your car and go. Good luck
jeff hallman is this true
YNGM Zaye I doubt it sounds ridiculous
It’s true it’s resetting the transmission
It’s true - apparently it’s only 15seconds for my BMW X3 tho
This is resetting the adaptations . Not the transmission
Problem in contlol or sensor
nice music in playlist!trance around the world mate :)
Danke.. Great video
U have to change ur gear ⚙️.. i had the same issue so i did change my gear 😢
how much did it cost?
samran nizam or change the trans oil
Is it the gear leaver to be changed
Czy muglbys mi powiedziec co bylo zle bardzo cie prosze . I jaka czesc wymienil
No hej. W moim wypadku spadek ciśnienia w pojemniku z olejem do skrzyni.Możliwe, że pęknięty jest Mechatronic Seal Adapter (nie wiem jak po polsku się ta część nazywa). Mechanik powiedział, że to bardzo częsta usterka. Możliwe tez, że masz za mało oleju w skrzyni. Proponuje sprawdzić u mechanika pod tym kątem.
A jama takie symtomy rze mi ciezko pszezuca biegi
radkar275 brak mocy w batteri albo nie wystarczajaco oleju w skrzyni
If you have a power drain on the battery this is a common error
Doug Quaid I tried to start my car, it was cracking but not starting, then I got the transmission fluid pop. I turned it off then started it , it started properly and the signal disappeared, could it be a battery drain ?
Hey i did service on my 2008 bmw 750li nd i disconnected the battery as soon i connect the battery nd started the car it gave me the warning of faulty transmission drive motherly
Had this problem today, disconnect the ibs sensor
It help?
Love a good jeerbox 🤪😭😅.. but well done for being able to speak English.. I gather it’s not your first language..
TRANSMISSION FAULT , EASY FIX....IST....CLOSE THE DOOR PUT SEAT BELT ON...2ND....TURN KEY TOO #2.....3RD...HOLD GAS PEDDLE DOWN , YOU WILL HEAR A CLICK, HOLD DOWN AND COUNT TOO 43..THEN TURN KEY OFF, THEN TURN CAR ON THEN TRANSMISSION FAULT GONE......
Alfonso Ferguson turn key to #2 mean?
Is this a joke?
That’s a transmission reset. Not always work.
That gotta be a joke , count to 43 . lol . Since im desperate ima try it 😭😭
Si solucionaron el problema amigos ayuda
Good music :)
Thank you
i got the same problem with my E70 X5,
me to i chance megatronic and other parts and still said transmission malfunction
hi have you fixed the problem?
Wtf is a jeer box
get over it man you dump,, You just dont like a guy with an accent . He is smarter than you
Its a gear BOX idiot
@@nerdinside21 calm down son..
Lol. English is not his first language obviously, that’s all.. he’s done well. How many languages you know?
Transmition joistik it cost's about 50-70 eur. :)
Ponga en español
Español
Решение проблемы
ruclips.net/video/GWV_WeljS9I/видео.html
Omg what are u saying
Useless
Crap plastic cars