To get the most accurate readings you are supposed to take readings in multiple spots and depths avg them together. But you can also take a reading in the dead center and multiply times .9 to take into account the center will have the most flow vs the outter edges of the duct.
Can it measure compressed air flow and pressure? If yes then will be an insertion type or some other method? Please explain
With this tool, would I have to sample air flow readings at several spots in the duct (high, middle, low) to get an accurate cfm reading?
To get the most accurate readings you are supposed to take readings in multiple spots and depths avg them together.
But you can also take a reading in the dead center and multiply times .9 to take into account the center will have the most flow vs the outter edges of the duct.
Nice review of a good looking product.
Sure is! Hard to go wrong with anything by fluke! Pricey, but you know you are paying for quality
Could u let me know Where is the temperature sensor bro? is it on the between of the two hole?
Does it check WC ?
Como lo traduzco en español
Puede traducirlo L español por favor gracias