Roof moulding weather stripping. When we had a C4 we had leaks during florida rains and washes. Water pooled in the floors. New rubber moulding fixed our floor water pooling. The C4 has alot more flex than the C6s as well.
@@Matty.Garage btwn the windshield trim and the weather strip, especially if the windshield has been replaced, missing the sealant behind the weatherstrip retainer trim. i see it all the time. and, again this, 3 drain udders. one behind pass side gill panel, 2nd btwn wiper motor and brake master on firewall, and third behind battery. your carpets , if they were the factory carpets with the black mass backing, should have been taken to the carwash and blasted. i do it all the ti,e. the squiggly hot glue was factory. i use 3m spray 90. nothing else works as well, allow for tacky time. i would have bought the factory carpet off you mould and all.
If the seat movement works then you can get to the lug nut wrench by just putting the seat as far forward as it goes and then unscrewing the pieces holding the wrench down.
I would check the targa top for leaks. It could also be the door window seals to the top. Also, the power seat switch panel is worth a few dollars to the 91-94 C4 owners.
Check you heater core in dashboard
Roof moulding weather stripping. When we had a C4 we had leaks during florida rains and washes. Water pooled in the floors. New rubber moulding fixed our floor water pooling. The C4 has alot more flex than the C6s as well.
Yes! Will replace it for sure!!
Windshield sealant. Check drain tubes.
Thank you sir for the tips!
@@Matty.Garage btwn the windshield trim and the weather strip, especially if the windshield has been replaced, missing the sealant behind the weatherstrip retainer trim. i see it all the time. and, again this, 3 drain udders. one behind pass side gill panel, 2nd btwn wiper motor and brake master on firewall, and third behind battery.
your carpets , if they were the factory carpets with the black mass backing, should have been taken to the carwash and blasted. i do it all the ti,e. the squiggly hot glue was factory. i use 3m spray 90. nothing else works as well, allow for tacky time. i would have bought the factory carpet off you mould and all.
Also, when you wash the car, you should have the windows rolled up. Follow me for more helpful advice. 🤣🤣🤣
Great idea!!
If the seat movement works then you can get to the lug nut wrench by just putting the seat as far forward as it goes and then unscrewing the pieces holding the wrench down.
cool tip the bottom parts of those seat are easy to come by hand with pinching the clip just right if u ever need to take them out on the go
I would check the targa top for leaks. It could also be the door window seals to the top. Also, the power seat switch panel is worth a few dollars to the 91-94 C4 owners.
Good job Matt! Sit in the car and get someone on the outside with the hose . I’m sure you’ll see it seeping in from somewhere. Good luck!
Yes!! Will do that!!
I'm enjoying the restoration videos. It just keeps snowballing. I still can't get over the lack of foot room for the poor passenger.
Keep it out of the rain, Corvettes melt in the rain 🤣🤣🤣
I need mini van 😅
Better find your water leak before anything. This car could turn into a money pit.
The C4 will prevail!