Thank you for giving the size of the chain. Can you tell me what type of air tube you use. When it gets cold where I live (My lasers in a shed) the plastic tube stiffens up.
Wisam, what size tubing did you use for your air assist? I'm about to install drag chains and would like to get a tube for air assist as well and not sure what size would be big enough to give enough air, but not too big to fit inside the drag chains. Appreciate your videos!
Dude! Thank you for such a good video! You actually answered some questions. So many ppl make videos over produced, with no real content. I am really glad I found your channel, splicing the wire is a very good solution! S U B S C R I B E D!
Wow, the hardest thing, BEND the profile without break it... GOOD JOB... and thanks for this, is just what I need... Thanks again.
Anytime
Excellent modification. Plan on doing the same thing to my Ortur LM2.
Thank you. This is just the video I needed.
Thank you for giving the size of the chain. Can you tell me what type of air tube you use. When it gets cold where I live (My lasers in a shed) the plastic tube stiffens up.
1/8inch
How did you attach the drag chain to the stepper motor end on the gantry?
I just used an l bracket attach it to the rail
If you use 18 gauge wire it increases the resistance slightly which may impact the motor speeds, I would use the correct gauge wire.
Wisam, what size tubing did you use for your air assist? I'm about to install drag chains and would like to get a tube for air assist as well and not sure what size would be big enough to give enough air, but not too big to fit inside the drag chains. Appreciate your videos!
Sorry I just seen this I believe this was 1/8 of an inch
Dude! Thank you for such a good video! You actually answered some questions. So many ppl make videos over produced, with no real content. I am really glad I found your channel, splicing the wire is a very good solution! S U B S C R I B E D!
I'm glad you like it my friend