This is part 01 of the wheel bearing replacement for 2012 Ford Edge.I did use a couple of special tools in here which i bought it from amazon..Enjoy watching
do you have both sides jacked up? When I removed the 24mm nuts off the strut and took those bolts out the lower control arm was under a lot of tension and pushed the entire hub up. I only had one side jacked up though...
Good job gentlemen, thank you for the information.
Great job brother 👏
Thank you so much 😀
Great info…Thanks for sharing !
Glad it was helpful!
do you have both sides jacked up? When I removed the 24mm nuts off the strut and took those bolts out the lower control arm was under a lot of tension and pushed the entire hub up. I only had one side jacked up though...
i only jack up one side
Anyone know if it’s possible to remove the studs without taking the hub off? Looks close
Yea just spin the hub till it’s at that little dip spot and wack it out that’s what I did to my 2010 ford edge
@@hunterswann676 thank you so much. I thought that’s what that was for.
Where did you get the cup bigger than the bearing? I have a 12pc ball joint press cup kit and none are larger diameter than the bearing.
amazon.ca
Powerbuilt kit 27
Thanks for that info!@@polarbear2469
Use a proper wrench on the inside and let it wedge against the lower arm. Jeez.....
sorry brother this is reality vs expectation and im no expert of this im just showing u a reality of doing a repair like this
Speak English if your in the USA sirs
watch my latest videos its all in english my friend