How to Fix a jammed Disc Brake /
HTML-код
- Опубликовано: 28 янв 2025
- After replacing new brake pads if you have a locked wheel, this video is for you. Fix in just 95 rupees!
PLEASE SUBSCRIBE TO MY CHANNEL AND PRESS THE BELL ICON TO STAY NOTIFIED.
IF YOU ENJOYED WATCHING THE VIDEO THEN LIKE COMMENT AND SHARE THIS VIDEO. THANK YOU!
FOLLOW ME ON FACEBOOK
/ rajib.sarkar.39
FOLLOW ME ON INSTAGRAM
/ ezmeck.yt
I have bee trying to fit a new caliper assembly (bybre) but brake pad is not retracting when lever is released. The slider pins and caliper floats are moving easily. Caliper movement is there but a bit uneven. Shall I drain out the brake fluid and try with new oil. Major kit is also replaced. Please guide. Thanks.
Thank you brother very much informative. I was facing front disc jam issue in my bullet.
Yes i think it royal Enfield quality issue i have also faced this jam issue
Very nice explanation and camera focus . Thankyou sir
Most welcome
He is right.
Some mechanics say that , the tightness of new pad will be reduced after few kilometres.
It's wrong .
Check new vehicle for double check
Your video was very informative. If you could help me with an issue in my Yamaha FZS rear disk brake. The issue is that brake pad are worn out unevenly. The outer brake pad has worn out a lot but inner brake pad is almost as new. What could be the reason as per you?
This usually happens when two parts of the caliper are not free to move. Separate two parts lube the caliper pin( don't use general grease, use Vaseline or silicon grease), use a set of new rubber grommets, and you are good to go.
But the pulsar caliber is of Endurance .I watched others videos as well they are using same part number kit for endurance caliber .I want to use this kit for Gixxer ,What do you think ?
Ye calliper Yamaha FZ 16 V 1 mein fit ho jayega kya ???? Yamaha genuine accessories shop mein available nahi hey
Ha FZ v1 me fit ho jayega, oil seal same hai, dust seal Sayed nehi lagega.
Cbr 250r non abs model e bybre caliper ache tahole ki same 220 minor kit fit hobe ?
Is the oil seal of szr same for fzs old model 2012 .
No
Is this bajaj ring suitable.for Yamaha fz version 1 .bybre.
Because one mechanic told me it's different
Dust seal is different but oil ring is same.
@@EzMeck I changed it, still stuck .Can I remove the dust seal only ?
New disc shoe lagaye...tyre jam..brake lever kit ka problem bataye...to caliper saf krk leneka ya kit change....gadi giri thi slow speed rainy season
Piston press karke caliper k andar tak ghusake dekhna hoga. Fir thik se bleeding karke dekhna hoga.
Very informative, my mechanic said same thing when I asked about wheel freeplay
Same.thing happened to me also
Excellent explanation video bro you gained a subscriber 👌 😊 keep it up.
Thanks mate!
Which model disc hose cable you used please reply me
Its a Chinese product I bought from AliExpress
@@EzMeck how much cost and it's how much length
Bro can we use this kit in fz v2 caliper??
Yes, dust seal may be incompatible. Oil seal is the same.
2011 model CBR 250 forend barek calepar piston oil sel konca lagaya Babrye calepar ha bhai please
Piston 1 chote 1 bary hay
Thanks bro
You did the great job
Such an informative video bhai!!!!...Dual horn o tomar hi tutorial deeye lagiye chilam...aar eito korbo.. Thank you 🎉🎉💖💖👏👏👏
Bhai amar kache fz v3 ache abs model...ache (2020)seta teo ki ei bajaj er minor kit ta lege jabe???
Yamaha khaali O rings daye...grease daye na..
amar 1 ta piston othe(Rise)...2nd ta othe na...1st ke push kore raklei 2nd piston ta othe...
kalke vim liquid mix jol deeye dhuye ektu wd 40 deeye rakhlaam toh bhabchilam ki ek bar service kore newa jaye
**Current situation...chaka ta free hi ache.**
Wheel free thakle r stopping power thik thakle kono problem nei caliper a.
@@EzMeck okay dada
What are wood and insulator parts? Ty for the video. Super
Boot and insulators are also from pulsar, they are available at yamaha as well.
Thanks bro.. i had same problem..thanks man
Welcome mate
I have same problem in my fzs v1, so which minor kit should u prefer??
Try to get oem seal kit, if you cannot find one then go for pulsar.
@@EzMeck ok thanks for the reply
I used endurance for fz , it's too tight .but fit inside the cylinder.Still same problem
I have a glamour fi. which minor kit suits for it
None, need to change caliber, what you had did?
Apache rtr 160 me meri yehi problem hai prr uska disk ghiss chuka hai per abhi kam kar raha hai, new pad dala hai per wheel jam chal raha hai local mistri bolte hai disk change karne p hi thik hoga. Kya ring change karne se thik ho jayega ?
Agar plate bend hai to plte change karne se thik hoga . Nehi to or jam ho jayega.
@@EzMeck bend toh nahi per bhai disk plate thin ho chuki hai bas
Hi bro I want to change r15 v2 front disc dust seals and oil seals .
Pulsar 220 dust seals and oil seals will fit to r15 v2
Yes same
Bs4 or bs6 model of 220 please tell me excat model of 220
Bs4/bs3 all will do.
Same kit can be used Yamaha FZ front brake
Very well explained.
Glad that helped!
Can i get the caliper toolkit for activa 125 (2016) ???
Does this toolkit suits activa 125
Sorry, I am not sure about that.
The video is very good. Can you please give the cost estimate for such repair? What is the cost of the new kit? What is the expected labour charge?
These questions regarding labour charge and other related charges are in the mind of public. We don't want to be cheated by local mechanics nor be taken advantage by Authorised Service Centers. Only you can help.
Bajaj caliper minor kit costs 80inr, labour charge 200-250 rupees.
Kaun si bike hai
Thanks bro❤️I'm from sri lanka
Glad you liked it!
Can we use the same Minor kit for CBR 250R non abs that has Bybre brakes ?
Is question ka jabab do koi same problem mujhe hai
Bhai apko abhi tk pta chala kya cbr250 ke liye kon si kit lgegi?
@@Indian_fun01 GT650
Bro I install new brake lever is that Also one of reason of jamming
I don't think so,
Is there any leakage over the time using bajaj spare on yamaha
Till date I have not found any such issues. They are equally good if not better.
wat bajaj did you use to replace the stock seal
Pulsar 220 bs3 model.
Yeh brake pipe kitney ka liya red wala aapney ??
500 INR
@@EzMeck steel braided cable ?
@@Sumitk658 yes, this is a chinese one, you can buy pulsar 220 braided lines, which will cost you around 1200inr. If you want imported lines then go for Hell.
@@EzMeck thx bro
My Honda Aviator Scooty Front Combo Disc is Jammed .. honda service center said that it is impossible to be repaired and, it should be replaced with new one and it cost 4000/- ...can it would be repaired Bro...? Hope an Early replay from you
I dont know what is wrong with it for which it cannot be repaired. But it should be repairable. Try consulting with other trusted local mechanics. Svc guys are always out there with replacement policy, they dont know how to repair.
Bhai Please is yamaha fz ki full wiring ki video banya na,ek ek tar ki jankari k sat
Wiring ki jankari dena possible nehi hai, kyuki wire alag karne k liye mujhe wiring ki upar wala insulator hatana parega, jo mai nehi karunga.
@@EzMeck bhai muje fz ki wiring samaj me nahi ata ha
Hi, I have changed MC kit for my RETB, but noi oil is coming out from master cylinder. What is the reason?
May be while fitting the mc kit seals were damaged.
Bhai mere bike discover 150 4valve hai or front disc brake lagate hai to bar bar chipak jata hai air nikalne ke badd bhi brake lagate hai to chipakta hai problem kaha pe aa rahi bata sakte ho kya
Calipers me orings rehte hai, use replace kardo,
@@EzMeck thanks bhai
Very very excellent sir
Thank you
Bhai Disc se b issue ata hai kya yeah ?
Ha ho sakta hai, uske upar jaldi video ane wala hai
Disc tit ho to b thoda jam chalta hai kya tyre
Bhai mere bike mai yeah 2 Din se Ho rha hai pr koi mistre theek nahi kr pa raha sab paise kha rhe hai yr
maza aagaya bht acha
Thanks a lot.
Super information
Glad that helped.
Brother Meri cbz extreme he uske ye fix ho gye up down nahi ho rhe
Same kit can be used for pulsar 220f 's rear brakes??
Btw very much informative video bhai♥
No rear brake is different.
@@EzMeck ohh can you give the part no.🙂
Ye jo saman badla aapne ye kitna ka hai hunk ke liye kitne ka milega
Nehi, hero ki parts different hai, iski price 100 rupees thi, hero ki thori mehengi hai.
Maine caliper naya install kiya fir jam kyo hai
Bhai mera piston bhot jada bura jammed hai bhar nahi aa raha hai. Suggest something.
Bleeder valve se compressed air flow karwao, nikal ayega.
Thank you brother
Thanks mate!
Welcome
Dada Amar new Gixxer sf Moto gp.700km hoeche,but bike ta 58/60 cross korlei handle bar e kichu vibration asche ETA ki normal dada??bolo ektu
Body panel theke vibration er jonno particular kono ak rpm a erokm vibrations ase, eta normal. Kichu korar nei.
Ok thanku dada.r kon engine oil ta use korbo ektu bolbe dada.
Motul 7100 10w40
Which bike is this?
SZR
For fz 1, which kit we can use?
You did good job bro,
I dont found video of oil change after this?
Same for fz v1,
ruclips.net/video/0DvNlel8HVo/видео.html
Check the last part of this video for bleeding process.
Sir shine sp gadi me samne wale breaker ya gadde se jane par chakke me se Disc Break se khat khat ki aavaj kyu aati hai iska kya upay hai.
Rubber boot or insulator ki problem ho sakta hai
@@EzMeck but sir showroom se lai tab se hi yani har shine sp disc bike me aati hai vh kyu aati hai
Reliable video 👍👍
Thank you.
I changed o ring, and seal but it's hard to put back the piston, what to do
Use some diluted grease
@@EzMeck how to dilute great.Sorry for the questions.No one helps .Thatsy
@@sudheerm.s6792 use brake oil with grease, or use silicone grease.
All royal Enfield owners plz don't use this kit as it is not the same size use royal Enfield geniune product
Did you try on same bybre caliper?
@@sudheerm.s6792 yes in royal Enfield both the oil seal are small as compared to this
@@PS0315 happened to me also
.
First I used pulsar o ring and dust seal.
Tight condition.
Again I used endurance.
Same problem.
My bike.is to Yamaha fz v1.
When I use the mentioned rings , it's very hard to put back the piston.
Not like the videos.
bro mere gixxr ka fron wheel na aagey ja rha he na piche cant move ..disc lock ho gya he kia karna chaiye
aur jo front brake level he wo ekdm lose ho gya accelerator k paas a jata he
You have to replace caliper o rings, and have to check the condition of the pistons, replace if necessary. The problem will be solved.
@@EzMeck bhai caliper o ring ya piston o ring kaunsa?
mere ek dost ka hua usne piston o ring change kia thik ho gya
Piston me koi scratches ya dent nehi hai to piston thik hai, or rings dono hi change karni hai, oil seal and dust seal,
@@EzMeck will let you know today
thanks bro for the response☺️
Jaruri nhi hai air ke karan vi jaam Hota hai ye nhi bataye mere pulsar me air ke karan jaam tha air ko nikalte hi free ho gya.
Szr me yehi problem aati bhai 🙏
Amar notun bike but disc brake sobsomoy jam thakche. Service cente bondho.
Ami ki tmr step follow kore service korte pari? Warranty matter korena!
Just problem solve chai
Go for it, if you need any further assistance dm me on insta.
@@EzMeck how much needed for full brake oil change?
100ml oil will be sufficient.
Caliper minor kit
How to take out air means spongy air brakes
Holding the piston with a cloth while pulling out would be better..
When it's jammed no matter what you put in between, it will create dents, when using pliers.
👍
👍👍👍👍👌👌👌
I did the same but it's happening again
Maine new disk lagwya hai jam ki wajase. Firbhi jam horaha hai
Bleeding video link pls
👍👍👍😄😄
Hamesha mechanic yehi bolta hi naya hi toda time lagega
Kaun si bike hai
👍