How to connect a new wall to an existing wall/wall starter kit.

Please like share and subscribe my channel. Thanks

[@unholy7324]

Thanks for doing this with no sensationalism

[@anthonythomas6012]

Thank you for sharing.

[@johncavill1139]

i think the ties that go into brick courses are too short to tie the walls very well I used roof straps on my extension

[@SamDaviesBuilder]

Definitely not too short, I have been using these for years and they are very strong - try taking a wall down that is attached to these.

[@abulkalam5724]

Is it safe if we drill in brick joint ?

[@akabrickmaster8714]

It is safe 👍

[@robsimmons3818]

TUT TUT !!!!!!

[@davesmith729]

AmaZing great demonstration mate

[@akabrickmaster8714]

Many thanks

[@peterbigo9951]

The manufacturers don’t recommend you cut them, you should use the full lengths.

[@paulcollins6221]

No vertical dpc

[@thecurehouse-pete-walkabout]

Why would you meed a verticle dpc when joining to an outer skin?

[@SamDaviesBuilder]

To stop damp tracking from outside to the inside of the wall. Part of the brickwork you see in the video will be outside and part will be inside the new extension so the vertical DPC stops the damp tracking through.@@thecurehouse-pete-walkabout

[@simonmusticone9079]

Have you got a detail on how to fit the vertical DPC? ​@@SamDaviesBuilder

[@SamDaviesBuilder]

@@simonmusticone9079 no, I need to make a video of it. I usually run it 25mm in front of the cavity insulation (50mm air gap from cavity insulation to outside block/brick so DPC should be 25mm back from outside skin of block/brick)