Honda Push Mower HRR2169VKAA With A GCV160 Engine | Made A Bang And Locked Up!
HTML-код
- Опубликовано: 8 сен 2024
- Honda Push Mower HRR2169VKAA With A GCV160 Engine | Made A Bang And Locked Up!
Let's Tear It Down And See What Happened!
www.strikehold...
#strikehold #capritools
I was yelling at you right from the get go Tom that it was a valve. That sound/180 degree thing is hard to forget. Had the same thing happen to a 14.5 Briggs vertical a while back. Piston was gouged but not cracked or punctured, put it back together with a new exhaust valve and 7 years later it's still running well. Enjoyed the video. Keep them coming!!
Never dealt with Honda valve covers but, depending on the type of material holding on the valve cover, a torch and a little heat may soften the sealant enough to pry it apart without damage. Same procedure I use to remove LCD screens on Phones and Tablets only I use a hotair gun and not a torch. Good video. Thank You...
Wow. Never seen that on a Honda before
Cool ……. Get your self one of those endoscopes next time you pop into harbour freight 😊
Unusual for an intake valve to fail, they run pretty cool. Possibly the low oil affected the governor and let the engine over rev. I lent my edger (gvc160) to a friend and forgot to tell him the governor wasn't adjusted correctly. He ran it full throttle (5,000 rpm's) for 20 minutes before the intake valve broke off at the retainer. It was ugly, I salvaged what parts I could. A sad ending to a great engine.....AL Scott
Small parts are inexpensive but that cylinder is spendy.. If customer says do it, replace both valves, new piston and rings, and a new rubber timing belt, and depends on how deep gouge is on the cylinder? might be able to hone it out enough to work.
Had one the sealer in crankcase came off got in governor under timing belt. Belt came off
Sixty five ford had the same problem this week on the same mower
makes me wonder why an intake valve would just break!
Wow that mower got around Tom Doby and Sixty 5 Ford worked on the same mower😮😮😅😂😂😂😂😂
Great detective work and thank you for the video sir 👍😎🇺🇸
Stress on a casted piece of metal , plus heat and pressure. The casting was probably faulty and developed over time to a crack , then totally broke away….. my guess
It just blowed up!!!!!
Such a shame that honda engine gave up the ghost
👍👍👍
I'm not Fonda of a broken Honda engine 😢😮
Did the retainer slip off the valve stem?
no it was still intact!
It's blown
Low oil ? Timing ?
Just low oil
Will strike hold fix it ?
A dab will do ya