Laser Poor Cut | Fiber Laser Poor Cut | Over-burning Cut | Solutions of Laser Cut
HTML-код
- Опубликовано: 20 авг 2024
- Our Store/Nuestra Tienda: spierlaser.en....
Contact: +86-13335151833 clara@spierlaser.com
The video says one of the laser poor cut, fiber laser poor cut, the over-burning cut. You can find the conditions and solution of laser cut overburning.
Helpful ... thank you
As usual, very helpful. Thank you!
You are 🤗 welcome
As usual Very helpful.👍
😀 thank you.
How to clear alarm 4limit
how about the wavy cut, the cut is not straight.
What kind of wavy? Could you show me a video?
Thanks, Do you have any information about cutting 2mm stainless without N2...only with air...pressure?, etc?
Could you check my another video, the parameters?
we love you ❤️
Thank you
Apa penyebab head laser panas?
Thank you
What about the frequency of a laser source? I think it even affects the burning, if it is a high frequency
From my experience, frequency is not a parameter changeable often.
@@ClaraChai Thank you very much,
but what is the effect of frequency if it is too high or too low?
how do we find the correct focus for Mild Steel for example for 4mm 5mm 6mm 8mm and so on. Is there any rule for that?
Reference and experience
Hi mam we use ispri laser head auto focus head but when I cut carbon steel with air like 3mm the focus position automatically going to -30 after coming alarm servo
+86-13335151833, please give me more.
Hi Clara . you didn't upload the focus tutorial video?
Later
@@ClaraChai Ok . Thank you very much for your videos , that you share knowledge.
during marking, it makes hole at corner
high power at corners how to solve??
There is a setting in CypCut for corner power, you can check my CypCut videos
Hi, please help, I was watching your videos. I am cutting Galvanized sheet of 0.8mm thickness. Now a days there is lot of slag formation at nozzle tip which is causing cutting problem. Please suggest how to rectify this problem. As there was no such issue while cutting galvanized sheet.
Parameters not changed? Is the nozzle hot? Is your lens checked?
@@ClaraChai Lens is perfect. Parameters are fine. Still at nozzle tip slag formation is happening inside the walls of nozzle
@@astitavsharma1238 Your laser beam is not in the center.
@@ClaraChai we have cross checked the laser beam centering. That is fine also.
Will it be the same for cutting stainless steel?
I don’t think so.
@@ClaraChai Thank you :)