Nooo I watched intently but then the bit you take latch off and say slide to right confuses me as I have a cable going into the latch wich I cannot get off arghhh
@@stephenbates2568 normally it is a t40 torx bit, t30 would definetly strip it! Some kits come with a t35 that might work. If not i would suggest trying flat jawed vice grips to remove it.
Great video, more insignia guide videos would be great 👍🏻
Excellent, should be similar on my Vectra c. Cheers.
Thanks
I’m trying to do this job at the minute. I CANNOT GET THOSE TWO SCREWS OUT for the life of me!!!
Did you manage? I tried yesterday and they are fucking stiff
Snap..... What you use to remove them
In the same boat any ideas
How do u know it's the latch or the boot opening stystem
Did you say 240 torx bit to remove the boot lock itself?
Why did you take off the parcel shelf mounts ?
So he could use the parcel shelf as a platform I'd assume
Nooo I watched intently but then the bit you take latch off and say slide to right confuses me as I have a cable going into the latch wich I cannot get off arghhh
is the cable the wire connector? it unplugs by pushing in the two sides and pulling!
@@iMrSpyro only 1 side looklikenits got a latch to press but I can't figure it out
@@amc7004
cannot get lock screws removed any help pleaseTHANKS
@@annoneill6081 why can't you get them off ?? Too tight ?
or was it T40
Sorry for the late reply, i said T-40
@@iMrSpyro t40 is to big8ve tried the 30 and stripped it any ideas ??
@@stephenbates2568 normally it is a t40 torx bit, t30 would definetly strip it! Some kits come with a t35 that might work. If not i would suggest trying flat jawed vice grips to remove it.