I have found this video very helpful and I just have to put this step by step into practice. I have a long way to go in getting my new monster truck started for the first time.
So I force feed mine fuel, and I started for about 5 seconds and then it stopped. I dont have a pull start it's an electric easy starter. It's trying to catch and start but it just can get there.
Thanks for getting back to me it's not from the head I think it's from the exhaust there a black ring I think it's coming from there that's why I asked the question I'm new to the game but loving it.
What engine is it? It’s normal for some to come from there because it’s only held on by one or two springs. Some are bolts like on the T-15 for example but most others are a rubber seal and springs
I'm unsure on engine make i no it's a 21 nover rossi I think it a old truggy hong nor crx c1 if that make sense there it's two springs around the engine.
Enjoy all your videos, and picked up a few tips from this one too. Any chance of a video about tuning these engines? I can never get mine to restart, after refilling the tank, unless I leave it for 10-15 minutes. Even then it’s a struggle. Use a roto starter.
Thank you for doing this video.... I have a working glow plug and fully charged glow starter.... I also tried the easy start method but it still won't start... I was worried is was somthing internal like crank shaft or cylinder head😢. I did heat engine with a hair dryer. Last time I used it(working) it was off the ground and it sped up turning wheels into pizza cutters... I lost exauste screws and gasket(I replace with new ones) my carnage still won't start. I will test for low compression later. After that I'm guessing a new engine is on the books😢
Just got a nitro and after 1 week trying i finally did it but seem like is throwing gas thru the exhaust and tank went empty in less than minute trying to break the engine . Any idea why? Anyone? Im new to rc cars
the do exsist compression tester but its not like with big engine. de compression is not the same every time it depends on how fast you turn the engine over and the heat that in the engine is different the compression is not the same ,
hello i have a 1999 toyota celika gt maybe older idk it was my dads rc car back in the day. Im trying to start it after like 6 years we hade sarted it. now it wont start whatever i do thank god i found this video that might help me make it run again the only problem i think it causes it to not start is the fuel bc it was sitting so many years in a garage maybe it wont have much power idk. I will try the things you sayd to do hopefully it will start?. i will update you if it will start!!!!😁
7:04 I prefer using cringe, I then do not need to cram my face to the model and I can see the fuel line easier ruclips.net/user/shortsxbbYzhld-vA?feature=share
This was a great detailed vid, thanks. I'm new to it use to drive full size Race Karts 2 strokes but my Biz lost $4M thanks to that idiot Biden so I sold them. Bored I tried RC Nitro, I like the miniature version of engine, suspensionods. Do you have a vid on upper lower needle settings? UK is Best for Motorsports !
![Blox Fruits Dragon Rework Update [Full Stream]](http://i.ytimg.com/vi/EqDAp8udhm0/mqdefault.jpg)
I have found this video very helpful and I just have to put this step by step into practice. I have a long way to go in getting my new monster truck started for the first time.
Have fun 🤘🏻
Me too, still struggling with three of the blighters, to even get one to start!
Nitro videos help wanted video you all way do nice job showing how to help people learn. Nitro thank you for making me videos 📹💯🔧
So I force feed mine fuel, and I started for about 5 seconds and then it stopped. I dont have a pull start it's an electric easy starter. It's trying to catch and start but it just can get there.
Great video very helpful. Quick question can you tell me why fuel is coming from the side of the engine or from the exhaust from the engine 🤔
Where on the side is it coming from? It might be from under the head if it’s not sealing properly
Thanks for getting back to me it's not from the head I think it's from the exhaust there a black ring I think it's coming from there that's why I asked the question I'm new to the game but loving it.
What engine is it? It’s normal for some to come from there because it’s only held on by one or two springs. Some are bolts like on the T-15 for example but most others are a rubber seal and springs
I'm unsure on engine make i no it's a 21 nover rossi I think it a old truggy hong nor crx c1 if that make sense there it's two springs around the engine.
Enjoy all your videos, and picked up a few tips from this one too. Any chance of a video about tuning these engines? I can never get mine to restart, after refilling the tank, unless I leave it for 10-15 minutes. Even then it’s a struggle. Use a roto starter.
thank you. was very helpful
Thank you for doing this video.... I have a working glow plug and fully charged glow starter.... I also tried the easy start method but it still won't start... I was worried is was somthing internal like crank shaft or cylinder head😢.
I did heat engine with a hair dryer. Last time I used it(working) it was off the ground and it sped up turning wheels into pizza cutters... I lost exauste screws and gasket(I replace with new ones) my carnage still won't start. I will test for low compression later. After that I'm guessing a new engine is on the books😢
If it revs up like that then the throttle is stuck open.
Where to buy that RC?
Maybe one - way bearings as well?
Well I guess that goes without saying too huh?
Well yeah that’s not really an engine issue is it 🤷🏻♂️
I live In the Caribbean so it's always hot here(like summer all year around basically ) should I still heat up my engines before I run them ?
Nah man it will be warm enough there it'll start fine without any heat.
There is actualy compresion tester for nitro rc car engine , but its ower 60 quid
Appreciate the help. Btw, if Andy Serkis ever dies, you could play Sméagol very well lol
I’ve never heard of it 😂
Just got a nitro and after 1 week trying i finally did it but seem like is throwing gas thru the exhaust and tank went empty in less than minute trying to break the engine . Any idea why? Anyone? Im new to rc cars
That’s normal with a new engine mate.
Loads of oil coming from then exhaust is a good sign, means it’s well lubricated.
the do exsist compression tester but its not like with big engine. de compression is not the same every time
it depends on how fast you turn the engine over and the heat that in the engine is different the compression is not the same ,
hello i have a 1999 toyota celika gt maybe older idk it was my dads rc car back in the day. Im trying to start it after like 6 years we hade sarted it. now it wont start whatever i do thank god i found this video that might help me make it run again the only problem i think it causes it to not start is the fuel bc it was sitting so many years in a garage maybe it wont have much power idk. I will try the things you sayd to do hopefully it will start?. i will update you if it will start!!!!😁
Did it start?
@@thatoneguy9819 nope it didnt
@@gameszly rebuild/replace most of the parts with the same versions and then gift it back to him for Christmas. Or don't, just an idea:)
40 1/2 and it's gotta be something
I am from Dubai but there is not repair shop
You did not mention setting needles when it won’t start
7:04 I prefer using cringe, I then do not need to cram my face to the model and I can see the fuel line easier ruclips.net/user/shortsxbbYzhld-vA?feature=share
Each to their own dude
EXPERIENCED😊
Don't suck on the pressure pipe if you have a full tank of fuel, makes you pull funny faces.
😂😂😂
This was a great detailed vid, thanks. I'm new to it use to drive full size Race Karts 2 strokes but my Biz lost $4M thanks to that idiot Biden so I sold them. Bored I tried RC Nitro, I like the miniature version of engine, suspensionods. Do you have a vid on upper lower needle settings? UK is Best for Motorsports !
🙏♥️👍
Sorry for my words but you should work on your explaning skills.
I always get told I explain things too much 😂