I'm surprised there are no comments on this video! Good idea! I wasn't aware you need to hone for 30 minutes! I have a cylinder with pitting near the glad only. Does that mean I still have to run the way through? Thanks for the video. If indeed it's needed for 30 minutes, I'm gonna have to duplicate your setup!
The honing time will depend on.how deep the pitting is and how course the grinding stones are. I suggest you check after 5 minute intervals. I also suggest you 'feather out' the grinding part way down the cylinder. Good luck.
I'm surprised there are no comments on this video! Good idea! I wasn't aware you need to hone for 30 minutes! I have a cylinder with pitting near the glad only. Does that mean I still have to run the way through?
Thanks for the video. If indeed it's needed for 30 minutes, I'm gonna have to duplicate your setup!
The honing time will depend on.how deep the pitting is and how course the grinding stones are. I suggest you check after 5 minute intervals. I also suggest you 'feather out' the grinding part way down the cylinder. Good luck.