Bottle Openers For My Groomsmen | My Tiny Workshop
HTML-код
- Опубликовано: 26 янв 2021
- Watch Andrew make bottle openers for his Groomsmen to be out of exotic wood cutoffs, and some simple hardware!
Follow me!
/ mytinyworkshop
/ mytinyworkshop
Support us!
ko-fi.com/mytinyworkshop 
Хобби
Good job bro
I like it so much! great job
Nice job! What finish did you use on the bottle openers?
S America not heared of twist tops, most other countries have been using them for years
They look incredible!! I'd like to make some for my colleagues, what were the diameters of the forstner bits (bigger and smaller) you used please?
Really depends on the inserts you end up purchasing! The ones I purchased were 40mm in diameter, so I used that size (or slightly larger) for the exterior hole. The smaller one in the centre needs to be small enough to fit between the screw holes, and large enough to allow a gap at the actual "bite" of the bottle opener. Probably a 22 or 24mm, if I recall correctly. If it's too large, the screws won't have enough wood to dig into, and could cause a break later on.
@@mytinyworkshop thanks man!
I came here for the same info.
I JUST got a notification for this! 🤷🏻♂️
Google knows that it doesn't mention animal rescues so it just cut it from your feed 🤪
16 more days.....congrats
What was the size of the two holes that you drilled into the wood?
what bottle opener insert did you use? looked like you were using screws that were longer than the inserts come with from like Amazon. amazing bottle openers!
Thanks Jacob! I used some bottle openers I found on Amazon. The included screws were not sturdy enough so I replaced them with some slightly longer #4 or #5s from the hardware store. Just had to make sure they would fit in the bevel!
What is the size and thickness
Please?
Hey Tim,
I think they ended up around 1" thick after all was said and done.
Você agora nnnjvg
Lose the music ffs