Any one in the wollongong area need to borrow the tool for valve springs? There $400 you can borrow mine, just dont f%$&k me over, it hurts paying for that tool.
dunno if you still have it on there mate!! but how was your front bar? im going to chuck one on my XT falcon. an wondering if it sat up under there nicely. !
Hi, cheers for the video. Just to confirm this is the cooler with 64mm inlet/outlet? Looking online at a kit for $430 that might be the same one. Thanks
The little pipe from the corner near radiator, goes to the sensor, remove it from the factory pipe under the headlight and silicone “vaccum pipe” goes onto it.
question when you done the valve springs did you not compress the cylinder to stop the valve dropping in?
Any one in the wollongong area need to borrow the tool for valve springs? There $400 you can borrow mine, just dont f%$&k me over, it hurts paying for that tool.
good video Man 👌
Appreciate it
dunno if you still have it on there mate!! but how was your front bar? im going to chuck one on my XT falcon. an wondering if it sat up under there nicely. !
Mine is a xr6/xr8 front bar, it fit with little trimming on mine.
$220 on aliexpress piping kit for BA/BF
100 mm thickness? Or 76
Hi, cheers for the video. Just to confirm this is the cooler with 64mm inlet/outlet? Looking online at a kit for $430 that might be the same one. Thanks
That is correct
Did that intercooler kit come with everything for the map sensor?? I've just ordered the same one
a tip: you can watch series at flixzone. Me and my gf have been using them for watching a lot of movies lately.
@Knox Zavier Yea, have been using flixzone for years myself :)
Where did you put the boost sensor? The sensor is bolted into the factory pipe.
The little pipe from the corner near radiator, goes to the sensor, remove it from the factory pipe under the headlight and silicone “vaccum pipe” goes onto it.
Thank you so much, also what factory pipe did you use to connect the alloy piping to the turbo?