How to Polish Motorcycle Forks - Fork Restore
HTML-код
- Опубликовано: 24 июн 2020
- How to Polish /Buffing Motorcycle Aluminum Forks - Suzuki GN Fork Restore
#Restoration #Repair #buffing
★ Dont Forget to SUBSCRIBE our Channel
★ Goal - 100,000 SUBSCRIBERS
=====================================================
★ LIKE | COMMENT | SHARE | SUBSCRIBE
KEEP SUPPORTING
Excellent thorough job...thanks a lot. I'll save this for the winter project, cleanup the whole front end.
They look great... well done.
Very nice job and you definitely done great work. 👍👍
Lankawe kollek neh 👍
awesome transformation!
Good video
I did the same on my sportie , except I used nitro morse first to get rid if the lacquer.
I also never sealed them with clear lacquer, that was 8 years and 30k miles ago .
A bit of autosol every now and again and they stay fine .
Laquering can yellow after a while unless you use an expensive 2k material
👍👍👍👍👍
good job bro. saw your vid and im going to do mine
Well done great job.
Thanks
Is that a 5 or 6 inch wool pad......looks amazing
You can get 3" now.
Stoch bright and wd40 then use polish
Is it a sander you are using for polishing ? If so please share the details with pad used.Good work👍
B cut super polish
What buffing pad was used ?
@@elliotbarron4913 You can buy felt discs for your angle grinder .
Makita car polisher..
Ayye...motorbike steel parts, kohomatha karanne ??? Same way haritha???
what solution is that? tap water? @Classic Enthusiast
Me davaswala newsuth thiyano😁
Add a little dishwash soap...makes the water 'wetter'.
Sand paper grade brother
Do you seal them with a clear later??
Yes
Nyalic is good for this
Is that a metal polish?
Alu polish probably
Why not use Scotchbrite instead of wet and dry??
a tip : watch series at Flixzone. I've been using it for watching loads of movies recently.
@Judah Angelo Yea, have been using Flixzone for since december myself :D
@Judah Angelo yup, I've been watching on Flixzone for since november myself :D
B cut polic kaha milegi sir
All you see is him sanding the big flat spots. I do this alot and there is ALOT more work getting inside the bumps and groves. This is very time consuming. I use a medium wire where on a bench grinder, seems to be the fastest and easiest way to clean them in all the corners and groves with no solutions needed. Even my way requires a die grinder with a medal wheel to get into some smaller corners.
Kindly list the grades of wet and dry paper you went through. Thanks.
He shows you each grit grades on the video before he uses each paper. 350, 600, 1200 I think from the top of my head.
320, 600, 1200 then 1500
Why didnt use paint remover? Hahaha
It's expensive where he lives easy to sand off...
I hate sanding
OK
FAKE SPRAYED ON GOO