Thank you for not skipping the embarrassing difficult parts. You showed us what it is really like and you gave us a good idea of what to expect. (If duct tape and silicon spray don't work, use a bigger hammer!)
На КРАЙСЛЕРЕ тоже переднюю ступицу менял, только полностью со снятием этой силуминовой каймой и под пресом удалось снять ступицу, иначе ни как не хотела подаваться и грели и стучали.
@waiswais8992 hello I have an insigbia and have done 2 hubs now one fron and one back. Absolute nightmare both times. Tried everything to break it free from spindle. On both occasion I remiv3d entire assembly put it in a b3nch vice then hit from back with a hammer
I would use the hammer to hit the handle of the puller - slide the hammer back and forwards on the Puller Shaft so bigger impact than just pulling with hands
noise can come from bearing or gearbox. to find out drive car slow speed 2nd gear then put in neutral with open windows and see if you hear if it comes from one wheel. then you will know if its bearing or transmission. if bearing breaks then its a problem so buy new one. Dont buy used one because you don't know how long it will last.
Thank you for not skipping the embarrassing difficult parts. You showed us what it is really like and you gave us a good idea of what to expect. (If duct tape and silicon spray don't work, use a bigger hammer!)
Most realistic car DIY video on RUclips lol thanks
На КРАЙСЛЕРЕ тоже переднюю ступицу менял, только полностью со снятием этой силуминовой каймой и под пресом удалось снять ступицу, иначе ни как не хотела подаваться и грели и стучали.
I'm gonna do this today doesn't look fun lol good work fellas
Hello, how did your wheel hub replacement go?
@waiswais8992 hello I have an insigbia and have done 2 hubs now one fron and one back. Absolute nightmare both times. Tried everything to break it free from spindle. On both occasion I remiv3d entire assembly put it in a b3nch vice then hit from back with a hammer
Ох мужики красавцы
I would use the hammer to hit the handle of the puller - slide the hammer back and forwards on the Puller Shaft so bigger impact than just pulling with hands
1:59 Какой размер ключа нужен для снятия осевой гайки?
32mm
Is this the same with the Astra k ?
Why you must change bearing ? Because from noise ? By the way - have you problem with balancings 17 inch wheels ? ( vibrations about 120km/h ?)
noise can come from bearing or gearbox. to find out drive car slow speed 2nd gear then put in neutral with open windows and see if you hear if it comes from one wheel. then you will know if its bearing or transmission. if bearing breaks then its a problem so buy new one. Dont buy used one because you don't know how long it will last.
How come your bolts go off so easy allover? I mean in reality, after 8+ years of use, the bolts don t go off and the one one brake disc always breaks.
Mission impossible