BILSTEIN B6 Camper Advanced and Eibach springs - EP35

Поделиться
HTML-код
  • Опубликовано: 9 фев 2025
  • In this episode I'm installing the front suspension. I think this is the best upgrade I've made for the van so far!
    👉🏻 If you missed, check out the PREVIOUS EPISODE: • Double Leaf Spring & B...
    👉🏻 NEXT EPISODE: • Kitchen upper cabinet ...
    Hi! My name is Diego and I'm converting a 2015 LWB Fiat Ducato all by myself.
    If you have any questions, please leave a comment below and if you enjoyed this video or found it helpful, please give it a like!
    ⭐️ Subscribe to my channel, if you don't want to miss the next episode!
    Instagram: / diegosvan
    #vanlife #vanconversion #vanbuild #fiatducato #bilstein #eibach

Комментарии • 18

  • @Roboll73
    @Roboll73 17 дней назад

    Hi! I did the same job, but with SACHS (314708 front and 314715 rear)....as the front spring I used Lesjofors 4026222 and I reach 4-5 cm more height than OLD! stock one. On rear I aded airbags kit from TIMPRO. All on the Dethleffs-Ducato camper. Good luck!

    • @diegosvan
      @diegosvan  17 дней назад

      Hi! Wow that's impressive! Is your van old? I mean with a lot of km on the clock? Because that may explain why you got so much gain in the front. Just a guess...

    • @Roboll73
      @Roboll73 17 дней назад

      @ springs were 11yo……
      are you satisfied with B6 shocks? On my present camper (also based on Ducato) I will change front spring. But I still dont know if these B6 shocks arent too hard compare to stock ones. I need more comfort and height. thx

    • @diegosvan
      @diegosvan  17 дней назад

      @ that make sense.. I’m really impressed by the Bilstein shocks. They are not hard at all. So much less vibration and much better control at high speeds. I’m going to install 4cm spacers on top of the front struts to gain some ground clearance.

  • @mausie1967
    @mausie1967 4 месяца назад

    That was a hell of a job. You did it!!!

    • @diegosvan
      @diegosvan  4 месяца назад

      Yes it was! 😅 So satisfied to see it done!

  • @rickt7425
    @rickt7425 4 месяца назад

    Just discovered your channel via your feature video on ‘Van a pian’
    Absolutely amazing- you’re a master craftsman / engineer
    Looking forward to viewing all your past and future videos.
    May ask you to come here in Australia and help me build a camper van 😁 I’m currently building a pop top camper for my 4x4 Ranger
    Bravo Diego 👍
    Enrico

    • @diegosvan
      @diegosvan  4 месяца назад

      @@rickt7425 thank you so much for the support from the other side of the earth!🤗
      So jealous you are going towards summer now.
      Good luck with your project!

  • @jimb7406
    @jimb7406 4 месяца назад

    Great video Diego thanks for sharing your upgrade. I am due to fit the exact same Bilstein B6 camper advanced struts to my van - so your video is very useful. The struts are currently on back order in the UK but I should have them in a couple of weeks. My van is the heavy chassis 6.36m length. I have weighed my van on a weigh bridge and fully loaded it is 1800kg on the front axle. My rear axle weight was exactly the same as the front. Like you I want to lift the front end and I have chosen Kilen 12181 motorhome springs. Just received them and they have 5.5 coils compared to the 4.5 to 4.75 coils on the original springs. I am hoping that the springs lift the front 40 to 50mm. I also have the same rear Bilstein dampers as you. I have the single leaf spring and VB air suspension on the back. Could you do a video describing how the van rides with the new setup? Does it reduce roll and sidewind movement? Is it comfortable over rough and smooth roads etc. Is the van any quieter etc. Look forward to a follow up video - well done doing the work yourself.

    • @diegosvan
      @diegosvan  4 месяца назад +1

      @@jimb7406 I'm happy that my video is helpful. didn’t know about those longer coils. That’s why I ordered 40mm lift blocks for the front suspension. Hope this is enough. Thanks for the suggestion, I’ll make a follow up video after I get to drive a little bit more of road and on the freeway. I have a small trip planned for next week. 👍🏻 And thank you so much for the support!

  • @tomaskolomy5248
    @tomaskolomy5248 2 месяца назад

    hi nice van and good job. can you provide part numbers for shock and springs for ftont and rear suspension.

    • @diegosvan
      @diegosvan  2 месяца назад

      Hi sorry to reply so late. I showed the part numbers of shocks absorbers in the video. I don’t have it anywhere now.
      About the back look at the installation video, I think I showed that as well. If not write me again and I’ll try to find them again.

    • @diegosvan
      @diegosvan  2 месяца назад

      This one: Double Leaf Spring & Bilstein B6 Shock Absorber - EP34
      ruclips.net/video/xt4KVaKz8_I/видео.html

  • @georgesdesk
    @georgesdesk 4 месяца назад

    Great video, how are the new tyres going, are they noisy or not to bad.

    • @diegosvan
      @diegosvan  4 месяца назад +1

      Thank you!! 🙏🏻
      The tires are doing well, a bit noisy yes but not that much. A bit more at a slow speed on sharp corners or roundabouts.
      And I think I’m not going to get a lot of km on them, they are wearing down pretty fast.

    • @rickt7425
      @rickt7425 4 месяца назад +1

      BFG All Terrain - quite and capable I’ve managed 75k km with them both on and offroad 👍

    • @diegosvan
      @diegosvan  4 месяца назад

      @@rickt7425 I was going to buy those but then I saw the Cooper at almost half the price so I tried.

    • @rickt7425
      @rickt7425 4 месяца назад

      @@diegosvan - you’re right. Off-roading setups here in Au can get expensive - tyres and playing with pressures is probably the most important part 👍