Fix First speed cooling fan bypass resistor Cooper s r53

Поделиться
HTML-код
  • Опубликовано: 16 янв 2025

Комментарии • 16

  • @andyfakeerjan9025
    @andyfakeerjan9025 Год назад +1

    Good stuff well done, very informative. Thanks

  • @northwest_hothatches
    @northwest_hothatches Год назад +1

    What size wire did you use? Or recommend

    • @fetos4309
      @fetos4309  Год назад

      Hi i check for you.. just founded message...

    • @shedrackikwabe3493
      @shedrackikwabe3493 Год назад

      Kindly share when you have an answer for the size of wires. In my case I used 1.5mm flexible wire. Though the resistor is getting hot, I quite not sure if the size of the wire is correct or not.

  • @stefano5981
    @stefano5981 6 месяцев назад +1

    Hi, I wanted to ask you if the original resistor is faulty, can I leave it in place without disconnecting it, with this modification you made? Thank you

    • @fetos4309
      @fetos4309  5 месяцев назад +1

      @@stefano5981 hi yes don't touch old resistor atm. this is bypass video guidance, i would advise to replace for new original type part resistor located in plastic frame engine fan.

    • @stefano5981
      @stefano5981 5 месяцев назад

      ​@@fetos4309thanks for the reply, I used two 10 awg cables but since they are large in diameter I put the yellow fastons connected to the resistor! did you solder the two terminals?

  • @dinosoul1
    @dinosoul1 Год назад +1

    bear in mind the resistor will become extremely hot, you may fix on some material surface like crash bar inside the bumper

    • @fetos4309
      @fetos4309  Год назад +1

      Hi thanks for adding important detail👍🏻 i did fixed to body using thermal paste and zip.

    • @chuckhayes8320
      @chuckhayes8320 Год назад +1

      I think what he’s saying is cooling fan will pull more and more current as it ages (I’ve heard usually 100k+ miles, fans begin to seize, unavoidable) more current means more heat in components, and as a safety measure a thermistor/fuse is used in the fan housing to break the circuit if temperature is too high in the components (caused by the increased current needed by the fan). This is to stop the fan burning out and potentially causing a fire. Likely it would just smoke as the coil burns out and melts some plastic but better safe than sorry!

  • @zurasadavenko4263
    @zurasadavenko4263 Год назад

    on what degree must wors first or second speed ?

  • @keithbaker9261
    @keithbaker9261 6 месяцев назад +1

    Power steering problem fails after about30 minutes you turn car off but when you start up no power steering have changed steering pump but still have problem

    • @fetos4309
      @fetos4309  5 месяцев назад

      @@keithbaker9261 Hi sounds like you need new power steering pump common thing with coopers, i'm just replacing mine now...

    • @keithbaker9261
      @keithbaker9261 5 месяцев назад

      @@fetos4309 pump has been changed 500 euros

    • @tolfan4438
      @tolfan4438 5 месяцев назад

      what year? I think there was a recall 2010.