Cheap Amazon Dewhel tow hook license plate bracket install on a Lexus is350 / is250

This video is about installing a Dewhel tow hook license plate bracket on a Lexus is350 / is250 Overall quality is decent for what you pay. As always I wish everyone a wonderful day!
Instagram link: / flukedracing
_________________
Disclaimer : Due to factors beyond my control, I cannot guarantee against improper use or unauthorized modifications of this information. I assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. I recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond my control, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Fluked Racing.

[@mouseandelephant]

Thank you for this. Seems simple enough even for a dummy like me

[@tonyhaywood619]

Harder part is putting the plate (and frame on the bracket. Should do a Part 2.

[@earlnicholson1490]

How has this mount held up over time? Do you have to tighten it here and there?

[@flukedracing7150]

It’s held up quite nice. I did have to add a washer in the front and back of the bolt that mounts to the stick. My only complain is that it sticks out more than license plate holders. But then again it’s only 20$ compared to the other ones that cost 80$

[@supertien832]

I got mine and it keeps drop down no matter how hard I tighten that sucker.
Car wash will be annoying. I should've get the removable one.

[@GangStarr4life96]

@@flukedracing7150 take a grinder to it. notch it down a few threads

[@sneakking101]

Has the license plate ever tilt or come loose ?

[@flukedracing7150]

Yes it has became loose once but I fixed it by putting a washer in between the the front side of the plate and the bolt.

[@sneakking101]

@@flukedracing7150 ok thank you thank you !

[@nathan22ortega]

Did you have to twist the first rod in half way ?

[@flukedracing7150]

I twisted it in as much as I could. Then with the second rod I was able to tighten all the way. A crescent wrench would help

[@nicomccabe9150]

Can you link the part?

[@jtns2845]

well done

[@mykeeee8448]

Any link to this