Thanks a bunch for the video. I tried programming my 70391 semaphore signals (I got a couple 2nd hand ones on the cheap) but couldn't make it work. Until I saw your process, including the step to do the programming with the signal on DCC on the configured address. The manual helpfully omitted that part... Got all of them happily bouncing now :)
Hello ! I’m not able to made the orange semaphore moving. The top one moves but the lower one is not moving, and both top light and bottom lights are blinking. Any idea what’s going on ? Thanks !
Hi Xavier, not sure what is going on. The lights should blink while programming, but this should just be briefly. Do remember that a signal with two semaphores occupies two addresses. What Märklin signal are you looking at? Are you using CS3/MS2? Are you using MFX, MM or DCC? Enjoy ;-)
@@ModelTrainFun the top one was moving ok, but as soon as I was trying to move the proceed slowly, both led blinked and nothing is moving anymore. must do a "stop" and release. The same behavior in MM or DCC and whatever adress is set via CV or dip. Finally it looks like the motor was not working. I opened the signal, unplug and replug the non working motor and now everythig is fine :-) I'm using MS2 with a recelty firmware updated. Now everything is working very straightforwardy like in your video:-) Many thanks !
@@ModelTrainFun before removing the pcb I moved the really tiny servo motor arm without luck (it was free to move but didn’t recover a good working order). Everything was back in track until I reseat the connector. I’m more buying false / bad contact :-)
![I.N "HALLUCINATION" | [Stray Kids : SKZ-PLAYER]](http://i.ytimg.com/vi/n5B5q1Hwt_U/mqdefault.jpg)
Thanks a bunch for the video. I tried programming my 70391 semaphore signals (I got a couple 2nd hand ones on the cheap) but couldn't make it work. Until I saw your process, including the step to do the programming with the signal on DCC on the configured address. The manual helpfully omitted that part... Got all of them happily bouncing now :)
Hi Kaasmeester, Glad you got it working - it looks very nice when the semaphore signals are bouncing. Enjoy ;-) Bo
Hello ! I’m not able to made the orange semaphore moving. The top one moves but the lower one is not moving, and both top light and bottom lights are blinking. Any idea what’s going on ? Thanks !
Hi Xavier, not sure what is going on. The lights should blink while programming, but this should just be briefly. Do remember that a signal with two semaphores occupies two addresses. What Märklin signal are you looking at? Are you using CS3/MS2? Are you using MFX, MM or DCC? Enjoy ;-)
@@ModelTrainFun the top one was moving ok, but as soon as I was trying to move the proceed slowly, both led blinked and nothing is moving anymore. must do a "stop" and release. The same behavior in MM or DCC and whatever adress is set via CV or dip. Finally it looks like the motor was not working. I opened the signal, unplug and replug the non working motor and now everythig is fine :-) I'm using MS2 with a recelty firmware updated. Now everything is working very straightforwardy like in your video:-) Many thanks !
@@tastetx I am glad you found the issue. Weird that the motor somehow was stuck? Enjoy ;-)
@@ModelTrainFun before removing the pcb I moved the really tiny servo motor arm without luck (it was free to move but didn’t recover a good working order). Everything was back in track until I reseat the connector. I’m more buying false / bad contact :-)
@@tastetx Interesting, but glad it is working now ;-)