Questions: When pressing the tabs to release the panel, which side do you press upon, the forward or back side? Next, have you ever had to replace the 'ice funnel'? How do you access it to replace it?
Nice job. After replacing my dispenser solenoid, I can’t seem to snap the display interface back into place. I pushed the top in first and I’m trying to push the bottom far enough that the tabs pop into their holes but they just won’t go in. So my display keeps falling off. The tabs are still there. Just not quite popping into place. Any suggestions?
James Whitaker, It is hard to guess what is causing the panel not to attach without viewing it. There is a possibility that the panel was manufactured by a third party and tolerances are not exactly the same as the OEM part. I encourage you to keep attempting to attached the part. You also might have to order a replacement from another source. I wish you success!
The place where the water comes out on my refrigerator is dirty. How do you get in there to clean it? It's not exactly the tub but it's on the side of the tub.
nice video sir, I have the same frig with the same problem where did you find the part it says discontinued everywhere I look online thanks for any help to locate.
It might be easier to squeeze the tabs on the back of the of the connectors, and pull them straight back, to remove them...
Great video Sir. wonder if you can tell us how to replace the gasket for the water dispenser it is leaking from.the bottom. thx
I am uncertain to which gasket you are referring.
Questions: When pressing the tabs to release the panel, which side do you press upon, the forward or back side?
Next, have you ever had to replace the 'ice funnel'? How do you access it to replace it?
Roger Laurel, The release tabs are underneath the panel and towards the front. No, the ice funnel has never gone bad.
Nice job. After replacing my dispenser solenoid, I can’t seem to snap the display interface back into place. I pushed the top in first and I’m trying to push the bottom far enough that the tabs pop into their holes but they just won’t go in. So my display keeps falling off. The tabs are still there. Just not quite popping into place. Any suggestions?
James Whitaker, It is hard to guess what is causing the panel not to attach without viewing it. There is a possibility that the panel was manufactured by a third party and tolerances are not exactly the same as the OEM part. I encourage you to keep attempting to attached the part. You also might have to order a replacement from another source. I wish you success!
The place where the water comes out on my refrigerator is dirty. How do you get in there to clean it? It's not exactly the tub but it's on the side of the tub.
If I were you, I would try warm water with a mild clearer. I would use a rag and/toothbrush to attempt to remove the material.
nice video sir, I have the same frig with the same problem where did you find the part it says discontinued everywhere I look online thanks for any help to locate.
I ordered a pre-owned panel that was on eBay. Parts are becoming more difficult to find for this refrigerator.
@@DIYFixer331 ok thanks