Hi I have a DIGITRAX DCS 52 For a year and a half the hand book I could not make any sense but now found this on you tube and was so simple. Kevin at ORWELL MODEL RAIL will be pleased no more hiding behind the stock.
Question. I have the older Zephyr DCS50. I run all my Locos on DCC and they work fine. However I just purchased an Athearn SD90 with Tsunami2 decoder installed. I can't get it to program. Is my old Zephyr just not up to the new DCC decoders? r
Hi, there. I have a strange situation with a couple of F units. The cab numbers are 1147 and 1147A. Do you know if there is anyway to add a 5 digit address with the DCS 52? Thanks
Hi thanks for your reply but what I meant was I have the main track wired in and the programming track as well how do I select the programming track over the main or do I disconnect the main while I program a train ( new to this lol) Regards
Hi I have a DIGITRAX DCS 52 For a year and a half the hand book I could not make any sense but now found this on you tube and was so simple. Kevin at ORWELL MODEL RAIL will be pleased no more hiding behind the stock.
finally can enjoy my DCS 52, thanks a bunch
No worries, pleased the video has helped you enjoy your DCS52 🙂
Hello, are there any plans to have similar step by step videos for adjusting other CV’s on the DCS52? Regards joe
Question. I have the older Zephyr DCS50. I run all my Locos on DCC and they work fine. However I just purchased an Athearn SD90 with Tsunami2 decoder installed. I can't get it to program. Is my old Zephyr just not up to the new DCC decoders?
r
Hi, there. I have a strange situation with a couple of F units. The cab numbers are 1147 and 1147A. Do you know if there is anyway to add a 5 digit address with the DCS 52? Thanks
As far as we are aware 4 digit addresses are the maximum you can use with the Zephyr.
I thought so, but it never hurts to ask. Thanks@@DigitrainsLtd
Hi thanks for your reply but what I meant was I have the main track wired in and the programming track as well how do I select the programming track over the main or do I disconnect the main while I program a train
( new to this lol)
Regards
When you select cv programmer/ quick decoder setup it will automatically switch to the programming track out put.
Hi I've followed your instructions and when I pressed write it only bleeped 3 times and the address hasn't changed!
I think some Digitrax units neeed updates. Mine does the same thing. I had to take my loco to a local hobby shop to change the address on the loco.