NOTE: If you want to replace the bearings in a John Deere X340 series mower, the top bearing is a non-standard NSK 6205-16 double seal bearing (25.4mm ID x 52mm OD x 15mm width). The bottom bearing is a standard 6206 double seal bearing (30mm ID x 62mm OD x 16mm width). I was able to press out the top bearing using a press with a 30 ton hydraulic jack. It made quite a loud noise when the bearing finally let go, so be prepared for that. The new bearing pressed back in without any problems, and I recreated the detents that held in the original bearing using a hammer and chisel.
NOTE: If you want to replace the bearings in a John Deere X340 series mower, the top bearing is a non-standard NSK 6205-16 double seal bearing (25.4mm ID x 52mm OD x 15mm width). The bottom bearing is a standard 6206 double seal bearing (30mm ID x 62mm OD x 16mm width).
I was able to press out the top bearing using a press with a 30 ton hydraulic jack. It made quite a loud noise when the bearing finally let go, so be prepared for that. The new bearing pressed back in without any problems, and I recreated the detents that held in the original bearing using a hammer and chisel.
How much did parts cost ?
did you say the clutch going out made the mower vibrate a lot?
not really
just noise
Next time....show the work.
Bearing is 'staked' in with all those indents. You have to remove it from that side and restake the new one.
Pro tip: watch series at kaldrostream. Been using them for watching a lot of movies these days.
@Kyler Malachi Definitely, have been using flixzone} for since december myself :)
buy a new clutch if the bearings are bad the rest of clutch is not far behind being worn out.
Price a new clutch lately?