Brittany, I followed what you did, other than I used 350 degrees for 60 seconds as that was what someone else had told me to do before I saw your video. However it melted the black that holds the metal ring. I watched your video (thank you greatly) and see that you didn't leave your ring or black area off the side of the heat press but it didn't melt the black; so can I ask where you got your blanks? Maybe it was the blanks that I got?
I'm so sorry for the delay. I get most of my blanks from Amazon. I would definitely recommend the Teflon paper. I feel like it really helps, but also, I'm not 100% sure if it wouldn't melt again.
![ian - Fit Check (Feat. VonOff1700) [Official Music Video]](http://i.ytimg.com/vi/sDGWDBg45Dw/mqdefault.jpg)
Thank you for the video. I was doing them all wrong! 😢
Great video! I was wondering how to do these and if you needed to hang the metal part over the side. Thank you.
How do you set up your design to print the 11 inches?
Brittany, I followed what you did, other than I used 350 degrees for 60 seconds as that was what someone else had told me to do before I saw your video. However it melted the black that holds the metal ring. I watched your video (thank you greatly) and see that you didn't leave your ring or black area off the side of the heat press but it didn't melt the black; so can I ask where you got your blanks? Maybe it was the blanks that I got?
Or is it because you use the teflon paper over the butcher paper too that stopped it from melting?
I'm so sorry for the delay. I get most of my blanks from Amazon. I would definitely recommend the Teflon paper. I feel like it really helps, but also, I'm not 100% sure if it wouldn't melt again.