Thanks for the video!! Although it's FAR EASIER to LEAVE the bar weight on the end. Roll back the handgrips so you can see the holes in the bars. Use a pointy object to rotate the clips sideways so the tabs go under the edges. Then spray with some light oil. Pull it out by the bar end.
I tried prying it out with screwdriver but did not work. I used the technique and it worked well. I simply grabbed the bar end screw with a pair of pliers and lightly tapped the pliers with a hammer and it came out! Thanks.
Sometimes just removing the bar end screw is a nightmare (red Loctite). I've had to heat it up on my Ninja 250, making a sheet aluminum shield to protect the grip.
So... If you don't want to damage the clip, just pull de weight till you se the clip, and with two flat screw drivers push to the center of the weight. And you take them off in half of this time and you can use them again.
Straight down to business. Clear explanation and no distracting music. I like it. Thank you!
Thanks for the video!! Although it's FAR EASIER to LEAVE the bar weight on the end. Roll back the handgrips so you can see the holes in the bars. Use a pointy object to rotate the clips sideways so the tabs go under the edges. Then spray with some light oil. Pull it out by the bar end.
Thanks for that, so easy when you know how
So simple. Thank you
Seriously good video mate, really helpful
Did not pertain to my particular motorcycle and was still helpful! Thank you
I have a 2011 PC41 CB600F, but I wanted to know how to remove it here! Thank you so much 👍
No bullshit what so ever in this video . Straight to the point . Thumbs up
I tried prying it out with screwdriver but did not work. I used the technique and it worked well. I simply grabbed the bar end screw with a pair of pliers and lightly tapped the pliers with a hammer and it came out! Thanks.
also works for the st1300, thank you for the video.
thanks man. very helpful. now I am able to remove my handle bar end with ease.
Absolute legend, you saved me some stress
Very good vid, tanx from Württemberg👍
Man, ive done it 100 times but one of my screws would not budge, thought I was losing my mind haha. Thanks
Sometimes just removing the bar end screw is a nightmare (red Loctite). I've had to heat it up on my Ninja 250, making a sheet aluminum shield to protect the grip.
Clip destroyer how do you install those barbed o rings? Any simple tools out there ? Thanks
So... If you don't want to damage the clip, just pull de weight till you se the clip, and with two flat screw drivers push to the center of the weight. And you take them off in half of this time and you can use them again.
I been looking for new ones to go in my bars for my 2009 cbr 1000rr
do i ned to remove the thing inside when i put on mirrors at the end or do i just ned to remove the first thing?
thank you it would be usfeul to see the removal of the accelerator bar as well.