Solar Glider DIY MPPT Solar Charge Controler

Поделиться
HTML-код
  • Опубликовано: 1 янв 2025

Комментарии •

  • @jafinch78
    @jafinch78 6 лет назад

    Awesome way cost effective. Amazing how the pricing has gone down so much for the RC hobbies and wishing more get into electronics in healthy, safe and generally well being ways.

  • @forfengeligfaen
    @forfengeligfaen 5 лет назад +1

    Thanks for the video! At 5:34 it looks like the FB on the XL4016 is connected to a PWM output on the Arduino. Is this correct? The data sheet says that the "Feedback Pin (FB). Through an external resistor divider network, FB senses the output voltage and regulates it".

    • @fpvdrone3159
      @fpvdrone3159  5 лет назад

      That is correct. The resistor network is removed and the FB pin is connected to the Arduino PWM pin. There is also a capacitor connected on this pin, this capacitor makes from the PWM frequency and voltage. On this way we could regulate the XL4016 with the Arduino (Mppt algorithm).

    • @alexandr_84
      @alexandr_84 Год назад

      @@fpvdrone3159
      Какая частота ШИМ?

  • @PavolFilek
    @PavolFilek 3 года назад

    I do not hear your voice, but music. how to understand how it works ?

  • @anthonyglare4806
    @anthonyglare4806 6 лет назад +9

    your music is TOO LOUD and your voice too soft

  • @ummubaydemir4424
    @ummubaydemir4424 5 лет назад

    Hi. I have a thesis project. I need to do Mppt buck converter. Have you ever done Mppt buck converter? Can U help me about this issue.Thank U.

  • @jeromegalleon1382
    @jeromegalleon1382 5 лет назад

    Do we need to remove / disolder the potentiometer, 1k resistor and the capacitor from the circuit?

  • @MrWidhio
    @MrWidhio 7 лет назад

    Would you be willing to share the arduino code? I have a few questions about how you've achieved it. Reference voltage is 1.25v, which would correspond to a value of 64 for analogWrite. How far above this value to you set to decrease or increase pulse width in the buck converter?

    • @fpvdrone3159
      @fpvdrone3159  7 лет назад +1

      I have uploaded a new video with the code. I have also calculated the 64 value, but during testing we found out that there is a different value. This is because the PWM value is not linear with the voltage. I have not yet measured the voltage. During testing we came out on a 146.

  • @suachuamaythammy.6396
    @suachuamaythammy.6396 4 года назад

    amazing

  • @alexandr_84
    @alexandr_84 Год назад

    Что делаете вывод D6?

  • @alexandr_84
    @alexandr_84 Год назад

    Можно увидеть код программы?

  • @forfengeligfaen
    @forfengeligfaen 5 лет назад

    Did you consider powering the motor directly from the solar panels and not having a battery? No battery and no DCDC would be a big weight saving. I tested this using a trust stand ruclips.net/video/bTIRTGlTLms/видео.html As the throttle is increased the thrust increases until you reach a certain point where the power drops off (as you might expect). Inverting the aircraft could be problematic. Maybe a small battery only for the servos and radios?

  • @forfengeligfaen
    @forfengeligfaen 5 лет назад

    XL4016 datasheet is here: www.xlsemi.com/datasheet/XL4016%20datasheet.pdf

  • @forfengeligfaen
    @forfengeligfaen 5 лет назад

    This is the link to the resistors www.ebay.co.uk/itm/64-values-1280pcs-1-ohm-10M-ohm-1-4W-Metal-Film-Resistors-Assortment-Kit/261374861457

  • @tremotinovolante5261
    @tremotinovolante5261 5 лет назад

    music louder next time

  • @tsitohainaranto1005
    @tsitohainaranto1005 4 года назад

    impossible to hear anything

  • @Ionizem
    @Ionizem 3 года назад

    Music is annoying AF