Hand Truck Power Station Step-by-Step Guide
HTML-код
- Опубликовано: 28 фев 2024
- Get this Goldenmate Orion 1000 Battery here: amzn.to/3Th92uw (10% Off code: 6TYRG874 valid thru 4/10/24) (Remember to add any coupons available on the product page also!)
Or here: bit.ly/3IgJkQl
Build your own hand truck power station on the cheap with parts from various sources. Get to know the individual parts of a power station including the intricacies of the programming parameters in the hybrid inverter. If anything breaks, you can easily swap in a new part or that you can even upgrade it as needed. Keep in mind though, since there are some exposed contacts in this power station, it is not child friendly and precautions must be taken when handling it.
Other items mentioned:
30000W Hybrid Inverter: amzn.to/3IkozU1
2 Awg ALFFAA inverter cables (1' to 3'): amzn.to/3Tdk5EO
Breaker for AC: amzn.to/3P0MCv4
Breaker for DC battery: amzn.to/3wx4gjw (Original cheapie one that might not trip right at 150A)
New Breaker for DC battery: amzn.to/48AGoZx (I will be using this one going forward while testing the old one to see its faults)
6' Extension cable 14awg 1875W: amzn.to/3TdkirA
Ring terminal kit: amzn.to/3Tcdevn
Fluke Multimeter I used: amzn.to/3ThLR3g
Buy the following at Harbor Freight but these are similar products at similar prices:
$30 150lb Hand truck foldable: amzn.to/49wDbM1
$16 Ratchet tie down 4 pack: amzn.to/3SYiIZf
#handtruckpowerstation #diypowerstation #backupbattery #orion1000 #goldenmatebatteries
Don’t beat around the bush, beat the bush!
I enjoy a good discussion but I like getting to the point even more.
► More resources at my Patreon: / beatthebush
► Mint Mobile, as low as $15/month: mintmobile.com/bush
► Moomoo, get up to 15 FREE stocks: Terms and conditions apply j.moomoo.com/008UFx
► Webull, up to 12 FREE fractional shares: bit.ly/2XwlcQ4
► Get $30 when you spend $30: www.rakuten.com/r/FRANCI7350?...
► FREE Audible Audio Book: bit.ly/2Z4RrN7
► Build Credit w/ NO Credit by Self-Lending: self-lender.3qcw.net/YYZBP
► BeatTheBush Honey Badger T-shirt: bit.ly/2FBAeLA
Watch my other videos at:
amazon.com/shop/BeatTheBush
/ @beatthebush
/ @beatthebushdiy
/ @beatthebushtech
/ channel
Keep up with me at:
/ thebeatthebush
/ thebeatthebush
/ beatthebush
WARNING & DISCLAIMER:
All published content is for informational purposes only, and any opinions expressed are our own.
BeatTheBush nor his representatives will offer you investment advice, investment services of any kind, and/or legal services. Please contact the appropriate licensed professional for such needs.
BeatTheBush nor his representatives will ask you for any private banking or investment account information. Please safeguard your data against criminal impersonators. Beware of scams often portrayed with misspellings of the social media accounts requesting transfers of digital currencies.
Copyright 2014-2023 BeatTheBush. All right reserved. 
Хобби
![Why a 48V System is Better than a 12V? [Vatrer Power]](/img/1.gif)
Wow! You gave me the inspiration to finally finish my solar project and was too scared without knowing the truth about the details. Great work
Awesome! The Orion is very versatile
Thanks for the build info. Love the hybrid tutorial, great buy being so versatile at ~$500.
YOU HAVE SEEMED TO BE INSPIRING MANY NEWCOMERS OF HOW TO GO DIY SOLAR AND THATS FANTASTIC . 🤗GOGO HAIH HOUH HOUH AH ! MAY THE SOLAR BE WITH YOU .
Solar is awesome, it's like magic. The energy does so much. Power computers, heat and cool. Oh my! Maybe wind power soon!
@@BeatTheBush 👌That would be great to include a wind turbine into your system which is very beneficial also for newcomers in diy solar .Hurricane Beryl is right under us in Houston Texas and many other events like the winter storm Harvey and power outages from ERCOT that it was a lifesaver .Check out my DIY solar videos , hit like , leave a comment and subscribe . May the solar be with you . Doh Jeh Neih !😉
You know the video we are all waiting for....
Love your videos
Good stuff. Just subscribed. Enjoy learning from your channel and please keep us updated on your 48v battery, if you can. Thank you.
Thanks for the sub!
Great video
Good stuff! Thanks.
For anyone that doesn't understand the huge voltage differences between minimum battery discharge voltage and the battery undervoltage recovery to turn inverter back on
Hysteresis-Often, some amount of hysteresis is intentionally added to an electronic circuit to prevent unwanted rapid switching.
The phenomenon here is the rapid voltage drop (in this case; if we are talking about the max charge voltage and the voltage at which it will start charging the battery again it would be voltage rise)
Because the very bottom and top of the LFP curve is so steep we could see the discharge current from the inverter drop the battery voltage back down to the battery undervoltage point if there is not a significant gap in between them. If there was only a 1V difference you would quickly cycle the inverter on and off.
For example
Minimum Battery Voltage: 20V
Battery Undervoltage Recovery to Turn Inverter Back on: 22V
Your average LFP battery that cuts off at 20V (for a 24V) will bounce back up to 22V EASILY within seconds after the load is disconnected. Sometimes even back up to 24V. With the above numbers the battery would fully discharge, inverter would stop drawing from the battery, voltage would rise back up within a few seconds, inverter would turn back on and before the load could even run for a few seconds it would likely drop back down to 20V. This cycle would continue going and going with less and less time in between each step as there becomes very very little capacity left at all (even under a small load) and eventually we would hit a point where the battery would never recover to 22V once the load is removed...but by that point I could see the system cycling 10+ times. A great way to blow up your inverter.
Max charge voltage of battery: 28.4V
Voltage at which charging can start again: 28V
LFP's resting voltage is below 28V so the battery would fully charge, cut off the charger and within a minute drop below 28V and start charging again.
Proper Voltage and which the charging can start again: 26.6V
The above number is just slightly under the voltage LFP rests at so it would take a load current a minute or two to draw the battery down that low....it would never reach that point if there was no load...it would likely sit at 26.8V'ish if recently fully charged but has been without charging current for an hour.
I once had a writing teacher write a note not understanding what a hand truck is.
I have that same inverter
Well done. Nice and good information
I think the real test will be to see how well that inverter is functioning 12/24 months from now, if you don't have to repurchase new inverters because the initial one is so cheap that it has a high failure rate then you're not really saving any money.
How do you make one of these for 240V split phase?
You'll need a 240V capable hybrid inverter. They might get bigger than this hand truck could handle.
In my case my reasoning for building this and using it would be to timeshift my electricity usage. After 4:00 p.m. my electricity rate almost doubles, and then after 9:00 p.m. it drops back down, and my big 85 inch TV sucks down about 700 W when being used not sure if this would power my TV for those 5 hours???
ha, cool
am I correct that this rig will only run that heater for less than a couple hours
Correct. On a full charge, it will run it for about 2 hours. Of course, this is expandable and you could put two 12V 200Ah batteries and run for 4 hours.
If the voltages are slightly different you can still wire them in series. Why would that matter
If one is higher and you charge it to 100%, one battery could end up being over charged.
Doesn’t each battery have its own internal battery management system?
go 48 volts
Just an OEM SRNE inverter
Dangerous - its not really earthed is it - its basically earthed to the cart = good way to get yourself - or someone else seriously hurt
That's a poor choice of handtruck for the weight you're strapping to it. Also, those resettable breakers are garbage. Watch the reviews on them. They will frequently allow as much as twice as many amps through before they overheat, finally trip, and are then completely destroyed. If you insist on using a resettable breaker, get one from Blue Sea Systems that works properly. Really, for the amps you're potentially pulling, a proper T-Class fuse is the way to go. Those are Grade-A, top-notch batteries, paired with a garbage inverter I wouldn't recommend to my worst enemy.
Hand truck is fine, it is within the weight limit and felt pretty sturdy. It is close to the limit to minimize cost. I do agree on the breaker being a cheap one and will replacing it. In the mean time, I will remove the recommendation from the video description and replace it with that one.
How is the inverter garbage, I got one! Yes 1yr now and does the job powering my washing machine, kettle, microwave and toaster also kitchen radio, it's within my budget and works ,so what's the down side if it functions and is affordable not breaking the bank
@@Andrew-ki5jz - 1 whole year? Well, if it's done what it's supposed to do for that long, I guess it's just the greatest product ever made.
Your dogecoin going crazy again and bitcoin at 62k dollars. We need dogecoin updates and crypto updates please. They are more memecoin ever in crypto this bull run. You can’t keep up at all.