information :44 the mass of these servos should be located Near the cg. and the cg should be located at Thirty percent of chord (or bit forward-of thirty). :49 the span of the elevator should not be truncated, as seen here. :55 there should be NO bends in a wire pushrod.! instead, Only make use of the inherent flexibility of the wire to run a pushrod, without bending the wire. no matter how it's made, a tail boom Should be tapered.! such tapering is a part of 'tuning' the dom of a model. dom is distribution of mass. the mass of ALL servos should be located Near the cg; NOT at the tail.! this prop is not correct for the application; an EP prop should be used. Electric Pusher. this is an example of an Offset Pusher thrust configuration. as such, the thrust Angle and Line NEED to be Adjusted; so that the thrust line Intersects the point where the c-m is Supposed to be located. c-m is center of mass. instead of using struts at the vert-stab, use glue FILLETS at the stab root. 1:03 it appears that the wing has a Wonky profile.! it should have the shape of the Upper surface of a clark-y or similar profile. googletranslate offset pusher thrust. the linked photo shows a correct configuration. ( the lines added to the linked photo do Not intersect the cg, however. the lines Should intersect at the point where the c-m is Supposed to be located. it should be clear from the information in this comment that cg and c-m are Not the same thing.) googletranslate static.rcgroups.net/forums/attachments/2/9/6/3/9/7/a5988257-224-bixler%202%20motor%20angle%20correction.jpg clark-y static.rcgroups.net/forums/attachments/1/7/5/0/9/1/a5237133-174-Clark%20Y.jpg
Best of luck ❤❤❤
I think u should try to speak in Hindi because it will make ur language more understandable for others 😌
I want FF vdo.
information :44 the mass of these servos should be located Near the cg. and the cg should be located at Thirty percent of chord (or bit forward-of thirty). :49 the span of the elevator should not be truncated, as seen here. :55 there should be NO bends in a wire pushrod.! instead, Only make use of the inherent flexibility of the wire to run a pushrod, without bending the wire. no matter how it's made, a tail boom Should be tapered.! such tapering is a part of 'tuning' the dom of a model. dom is distribution of mass. the mass of ALL servos should be located Near the cg; NOT at the tail.! this prop is not correct for the application; an EP prop should be used. Electric Pusher. this is an example of an Offset Pusher thrust configuration. as such, the thrust Angle and Line NEED to be Adjusted; so that the thrust line Intersects the point where the c-m is Supposed to be located. c-m is center of mass. instead of using struts at the vert-stab, use glue FILLETS at the stab root. 1:03 it appears that the wing has a Wonky profile.! it should have the shape of the Upper surface of a clark-y or similar profile. googletranslate
offset pusher thrust. the linked photo shows a correct configuration. ( the lines added to the linked photo do Not intersect the cg, however. the lines Should intersect at the point where the c-m is Supposed to be located. it should be clear from the information in this comment that cg and c-m are Not the same thing.) googletranslate
static.rcgroups.net/forums/attachments/2/9/6/3/9/7/a5988257-224-bixler%202%20motor%20angle%20correction.jpg
clark-y
static.rcgroups.net/forums/attachments/1/7/5/0/9/1/a5237133-174-Clark%20Y.jpg