Parrot ANAFI : HOW TO REPAIR
HTML-код
- Опубликовано: 4 фев 2019
- How To Repair Parrot ANAFI drone :
00:08 Preparation before any replacement
02:25 Chapter 1: How to remove the arms
06:09 Chapter 2: How to replace the motors
10:52 Chapter 3: How to replace the arms 
Развлечения
Would be nice if you include the Gimbal repair. A # of Anafi users have loss their camera following a crash, requiring them to dissemble the gimbal section to check for cracked pieces.
Awesome
Thank you so much. Followed your steps and successfully replaced both rear arms, my anafi flies like new again!!!!
Thank you, I successfully replaced an arm with no previous experience doing any electronics repairs before!
There's a massive omission in this video. My version of the ANAFI has the GPS cover fixed on by two more screws that aren't shown here. Any they are small screws - Torx T1 or T2 (don't know yet until my Torx set arrives from Amazon and I can try and remove the screws) But until you can remove the GPS cover you can't get at the arm fixings. So on later models you need an extra Torx size that isn't mentioned here.
Had the same issue, almost broke the cover before noticing the extra screws
Thank you, just saved my dron
Hoping to never have to do this, but thanks for the reference video. Very clear and concise.
Perfekt 🤩 thanks😍👍
My Anafi has drowned yesterday in a lake.....I found it on the bottom and.....after 24h with hair dryer(without opening it) It's ALIVE !!!
Good to hear its alive! how did it end up in water? Was it your fault or Anafis?
@@user-Chikotillo I was trying to land on the hand of my friend while we were all on a Yacht
I'm ordering the super long term extended warranty that covers all repairs.
Molto interessante!👍🏻
Ur video is incomplete you fail to show how to put the loading spring and small retaining clip back in during the assembly of the amateurs. What the hell
What about the back side of the main board where the sd card holder is? Suddenly at 2:27 the main board is lying on the table!
@Parrot Please provide that information. Not sure about what connector is meant to come.off and how so I don't break any connector please!
it says removed for visibility in the video
Very thoughtful.
Hello, the Blue light on my anafi doesn’t turn on what can I do?
I followed the instructions and when I attempted to unscrew the arm hinge screw, the head stripped completely. Any ideas? Nothing is sticking out of the plastic that I can grab. I have tried various tricks but none have worked so far.
My Anafi is having trouble maintaining altitude as soon as I take off sometimes he just drops altitude so fast he hits the ground. Can give you a clue as to what might be causing this behavior.
Remembering that he's not having trouble holding the position just his height.
Thanks.
At 4.47 mins in this video after at the start you bring in another screwdriver which (this is what I think ) you use to turn the bolt before pushing it out to release the arms. What screw driver is that ? I have followed this video to replace a rear arm and that bolt which holds the arms in place will not budge ?
I have problem with camera, do you have any trick, probably sand in the rotating system. Thanks for your help
Thanks for the video. To all naysayers you can buy mechanical parts from Parrot from their website, unlike many other drone manufacturers. This video is intended as a "guide" . You still need to have some mechanical/modelling experience and something between your ears in order to repair successfully.
yeah right... but your beloved "guide" is missing the most important AND difficult part. Removing the main board and most of all, putting it back. With the most fragile connector i've seen in about 40 years and the most piece of crap rubber shock absorbers money can buy. Probably an info your "something between your ears" has missed...
Well I have a broken rear leg and I am following this guide. At 4.47 mins you have to push the bolt out. They introduce another screwdriver which they don`t give you any info on to what it is size or type, it looks as though they turn before pushing the bolt through. So up until I find out what this is repairs have to stop as this bolt is solid and will not budge. As for their website I did try to buy a mechanical kit but as soon as you try to pay without using paypal it is downhill. More importantly no drone company in Scotland will touch this drone send it to Parrot they all say, problem with Parrot is they will not do the repair. I would also like to point out that there has been many questions addressed to Parrot on their official video and they have not responded to one, which is a bit of a surprise at I thought since Parrot do not have a customers support in the U.K and refuse to fix your drone they may be interested in answering questions in this video. This is not that complicated to fix if the video provided you with all the proper tools which they do not, even harder when they refuse to answer questions on the video. Parrots consumer advice wing is appalling more than happy for you to buy their product but cannot be arsed to help you fix it when it goes wrong. Best bit of advice that I can give is do not buy a drone from a company with no customer support in the U.K Parrot is that company. My next drone will be a DJI as everybody fixes them in Scotland which stops you going around looking for nameless screwdrivers from a company who cannot be arsed answering basic question on their very own You Tube video
Insane guy im gonna give 2000$ premier
Hab ein Ersatzbein bei www.dronivo.de (super Service, schneller Versand) gekauft und Dank dieses Videos war der Austausch nicht so schwer!
Parrot Anafi, no crash, up to date firmware. Starts up normal, but the gimbal fails to initialize. It twitches in one direction then stops. It will then repeatedly try to flick back as though trying to intialize again every once in a while. Any ideas?
anafi thermal suddenly went into emergency landing then it fell from the sky then it said engines have cut out, the obvious thing that is broken is the plastic brackets on the camera, do you have instructions and parts so I can repair it? I believe the camera itself is still intact other than the small micro cable came unplugged. The wire with the sections of shrink wrap is still in tact. what are my options? Thank you.
After a crash, I am not able to align the camera/gimbal back to the proper position. I've adjusted the camera up to the maximum of 5.0 ... but still need, the equivalent of, 2.0 or 3.0 more points of adjustment.
I have tried "resetting" the drone, as well as other things, but when I try to Calibrate the Gimbal, I always get the message: "Place done on a steady surface and click OK." Also, when it tries to do the calibration, it doesn't move properly as does my other Parrot Anafi.
And I've also tried doing it with my other Controller ... same result.
So, this makes me think that there is something wrong with the gimbal.
Do you know if when replacing the gimbal if the motherboard must be replaces as a 'matching' set?
If so, do you have any idea where these may be purchased from in the U. S. ... or a good repair company? Thanks
I am also looking for repair parts so frustrating. Did you ever find any help
What tool is used to remove that white bolt with clip on it??
hi there, where can i get my drone fix?? try my self but noo luck!!
Any other videos on how to repair? Such as drone not powering up?
I have the arm of my Anafi broken but also it doesn’t start. How should I start repairing? Thanks
How do you replace SD card connectors?
hello everybody here, what if we plug the 4 motor connectors and the antennas into wrong socket, will it still work? My anafi keep flipping before take off, and i dont think it's the propellers. thank you
Drone crashed sigh,arm beside camera cracked.can I just replace top or is it the entire body? Any one.also I see rubber type bushings between camera arms do they just pop out? Anyone?
Ohh yeah very good am i just magically ment to know how to disconnect the 2 additional wires on the back of the motherboard
For an official parrot video i have to say quite a let down
Do you have to take the whole drone apart to replace one arm?
Yup
i have a problem with the LED light
where do i attach the gps connector cable?
Please make available in the US
19:59 it says "place the gps board and fix it".... well ok but where does the wire get connected... they don't show that... can anyone help?
Anyone help
comment remplacer la nacelle et la caméra sur mon drone anafi merci ?
Where does the GPS GO
No video shows this
Man i wish they made a video of how to repair the parrot jumping night drones
the jumping sumo is similar, the tutorials of the jumping sumo are available in parrot youtube channel
@@pedro14275 yeah but they are different from the jumping sumo so yeah
@@tcterrence try waiting for the signal of the drone it takes 5 minutes to find it
@@tcterrence try using another device with android updated or a tablet
What is the size of screwdriver in 4:43?
How to fix the zoom? The zoom button doesn´t work
Ok, Ok... Where can we purchase the so needed ANAFI MECHANICAL KIT??????
lol they are out of the consumer drone business so good f'n luck, Skippy. Still gotta love that memory card holder from a 1990 cell phone. 1 cent cheap chinese crap, yep real build quality
www.parrot.com/it/pezzi-di-ricambio/droni/anafi-kit-meccanico#anafi-kit-meccanico-details
@@silbay . Another paid DJI troll??
www.cnet.com/news/parrot-anafi-thermal-drone-pairs-flir-thermal-and-4k-cameras-for-1900/
Amazon has the complete mechanical kit for $100 right now but it's not OEM so I'm not to sure about the build quality.
Anyone have any idea about what those repair tools used in this video are?
A t5 torx screwdriver and a pair of angled tweasers
介紹自己換零件可是卻買不到零件,鏡頭壞掉都找不到修理......
where dose the gps plug into?
David Woods seriously
@@cartechniques101icanfixtha2 hey could you be more specfic possibly I cant quite find it
@@bderx6508 what's ur email shit won't let me send pics because it's a no reply via RUclips or hit me up @ joshlunsford2000@gmail.com
@@bderx6508 I posted a video look up parrot ANAFI GPS motherboard location
@@cartechniques101icanfixtha2 i'm done except that antenna wire from the gps.. i didn't undo it.. i came off and i have no clue from where? can you send a link to that video?
My anafi doesn't fly but the blades spin... I changed it tho ... will that be the reason ?
I would try an match the prop arrows to the motor arrows I got them backwards once an the motors would power up but would not take off I would check that if you haven't already
Check blade/rotor rotation.
Each motor has two triangles on the rotor, indicating rotational direction.
This would be a better guide, if we were allowed to include images in our replies.
Great drone! But i hope I would never have to do this kind of repair, these motors should last, they are brushless after all
มันขึ้นแบบนี้หมายความว่าไง Verticalcameratailurepleasecontactparrotcustomerservice
Hola chicos necesito ayuda,la cámara de mi anafi no da señal de imagen,alguien me puede ayudar
I think we should first teach people how to use anafi instead of teaching people how to split anfi. In fact, you simply did not provide any repair parts that consumers can buy.
BRO YOU GOT BURNED
I have bought a rear leg from Dronavi GmBh and successfully installed the part and now my drone flies again
Whats with camera? it not Wayne Worlds "Camera 1, Camera 2, Camera 1, Camera 2, Chapter ends and the music? just why? can you not explain while you go? and this is the official channel?
The connector holder is too delicate to service without a spare onhand.
My daughters name is anafi
yeah, the directions were not very good. I followed it step by step and assembled my new legs, and after I put it all together, no my SD card reader won't read, and I can't record videos. I love the Anafi, but this was a very bad experience. The whole thing took over 2 hours and after all this, I can't record with the drone.
Do you have to take the whole drone apart to replace one arm?
@@gabadventures7127 Did you get an answer to this question?
Autant le vendre un quitte
Your video leaves out a lot of stuff, you don’t even explain how you take the ribbon and right front antenna that’s underneath the board off! You literally skipped that
so what can i do with the body? lol bad guide...
Dont even bother wasting money on the kit. Just toss and buy a new drone. I tried this repair and some of the plastic connectors broke off. This is way too difficult to repair.
there is someone that cloned your video in his channel > bHdM6rDCot0 < 👎
i think is not fair ...
RAT!
You skipped whole steps, like disconnecting and removing the memory card holder, and disconnecting and removing the circuit board with the vertical camera. And the copolng fun does not just pop of with a flip of the thumb. In fact it seems designed to not come off at all. This machine is disoposable and should be marketed as such. Parrot is a horrible company with lousy products.
You fucking kidding me? Parrot makes great products for good prices, professional photographers using Anafi to shoot videos for their work, I also use their products and never had issues, Bebop 2 was highly reparable, but Anafi is far more advanced, thats why its much harder to repair, but it doesn’t mean its crap or disposable, DJI drones also disposable but cost twice as much, just learn how to fly and you will never have issues...
@@user-Chikotillo Obviously some fanboy who hasn't tried to deal with the anafi mainboard yet.
@Benferno Totally agree with you
Oh no. Even a lady with red nails can do it, but feels like it could be a little complex for me.
hahahah, Red nails, ... and glasses, she's not just a lady, she's a cool lady that flies drones :)
If I live in the third world country I will try to fix it, but I live in USA I have no time for this, I rather throw the drone in the garbage and buy an other one, very simple!
New drone: 600$+
New arm: 20$ + 30 Min
I'll buy it
Send it to me, I will take the time to repair it...easy.