Mono Suspension in Autodesk Fusion 360

Hello,
My dear subscribers of Contour Analysis Channel. Thank you for watching the analysis video on my channel, I hope you will share and learn more by watching my video. sorry to say this, i donot save any analysis file or geometry what i done or created.
for contact: / contour.analysis
for support: paypal.me/contouranalysis (your wish)
for project : www.fiverr.com...
:www.fiverr.com...

[@ghaf4414]

the spiring is not modeled very well, but it is a good start.....good job guy!!

[@riddioughp]

There’s one big issue with this a spring has the last coil at the ends compressed, you’ve failed to capture that, it’s a part I cannot seem to figure out how to design, to reduce the spacing between each coil separately to the rest

[@excellencyism]

a spring should compress evenly across its length unless it is a poorly made or progressive spring..

[@forestisk16]

my problem is to make that spring move inside a unit

[@marfec0223]

dude just how fast are you? i had to watch it at 0,5 speed, 0,75 was still too fast

[@TheHamzaalikhan]

he's showing the video at a higher speed