Chevy Impala EVAP Purge Valve Replacement - Fixes P0442 Check Engine Light

Поделиться
HTML-код
  • Опубликовано: 16 ноя 2024

Комментарии • 15

  • @hazeew.6272
    @hazeew.6272 3 месяца назад +1

    I had no idea such a small part couple make such an impact. My car was struggling to accelerate up hills and at low speeds. I got it coded, watched this video, and changed it in less than 15 minutes. Feels like a new car now 😅 Thank you!

  • @MangoWrLd-kmr09
    @MangoWrLd-kmr09 9 месяцев назад +1

    Good video, thought it was going to be a hefty job. Gonna give an attempt tomorrow morning and give feedback

  • @Spider-Bite
    @Spider-Bite 2 года назад +4

    Been having this code off and on recently on my '10, I hope this is the issue on mine. Thanks for the vid. Btw, that camera bump at 1:11 nearly knocked me over. 😅

    • @tommyv5435
      @tommyv5435 2 года назад

      Could be against the firewall depending on the year.

  • @brucecook2261
    @brucecook2261 2 месяца назад

    I just replaced mine so we’ll see what happens I had this code earlier this year and replaced the purge valve at the tank, the CEL stayed off for 6 months and now the same code. I hope this solves it

  • @toptier33
    @toptier33 3 месяца назад

    What was the car doing that made you change it

  • @griffinscreationsantiques1999
    @griffinscreationsantiques1999 3 месяца назад

    Any idea where I can get this sensor? I’ve googled it, but they look different compared to the one in the video? Just don’t want to get the wrong one. If anyone has a link it would be greatly appreciated!

  • @GodFirst92
    @GodFirst92 Год назад +2

    I changed mine but my check engine light still on. Anyone know what could be the issue?

    • @FATMAC_365
      @FATMAC_365 11 месяцев назад

      Check the wire harness for cuts or splits and check the connection for corrosion
      And did you disconnect the battery to reset the computer?

    • @GodFirst92
      @GodFirst92 11 месяцев назад +1

      @@FATMAC_365 yes I disconnected the battery to reset but I'll check the rest out thank you

    • @DarthMasiah
      @DarthMasiah 8 месяцев назад +2

      my code had cleared at first after replacing this part, but came back a day later.

  • @Si1verRaven
    @Si1verRaven Год назад

    Does the issue cause the rpms to hesitation while accelerating?

    • @alfredough
      @alfredough Год назад

      It seems like it's possible can hurt acceleration and maybe cause rough idle. If you have that code just replace it like he did they sell the part for like 40 bucks at O'Reilly's easy to change very easy. Just be careful with the rubber hoses not to much pressure they'll break nd snap they're old

  • @joehagen7501
    @joehagen7501 2 года назад

    Thank you 😊