3D Printed Accessories for the Myford ML7 Lathe and Quick Change Tool Post

Two new 3D printed products for the Myford Lathe from SDM Design Studio, T-Slot filler bars to prevent swarf build-up, and wall mountable holders for the HBM T-37 Quick Change Tool post tool holders
SDM Design Website: direct link to product page sdmdesign.co.uk...

[@billofalltrades1468]

Brilliant ! A million dollar idea!

[@derekwilkinson7939]

There’s nowt like a good laugh first thing in the morning. A big furry bush on the end of your tool. HaHa. 😂😂😂

[@brianspence9230]

I used the aluminium tee slot strip available from RDG to fill the tee slots on my ML7. They were also a slightly slack fit so I recessed a small 7mm dia round magnet in one end which I stuck in place with loctite 638. This is enough to hold the filler strips securely. Magnets obtained from our friends in China via Banggood.

[@littleworkshopofhorrors2395]

if you get back in touch with him suggest a slight redesign in that he puts a curve on the lower side of the toolholder holder. it is much easier to place a holder on the top and rotate it downwards rather than have to align things before they fit. Another slight mod is to have the mounting face àngled so that gravity will keep the toolholder against the wall. Other than that I would give him 8 1/2 out of 10.😉😄

[@EmmaRitson]

good ideas!

[@billtabiner8925]

I was looking for a way to send you a private email but maybe that's not possible but your other self is going under the name of Ade workshop but was Ade Swash
regards Bill