Gordo (Pt.1 of 2) Machining SAVER subs - Pinnacle Drilling
HTML-код
- Опубликовано: 30 сен 2024
- #cnclathe #lathemachine #machineshop
You can check out Gordo's IG for more day to day machining he does:
/ sk8gord
Thanks so much for watching!
Be sure to like and subscribe so you don't miss out when we upload.
Have a look at our other channels for more information and what we're all about;
Website: www.pinnacledrilling.com
Instgram: / pinnacledrillingproducts
LinkedIn: / pinnacledrillingproducts
1/4” doc? I think you mean 1/8” doc, 1/4” removal.
Chatter on the finish OD cut, so typical 😒
When you're trying to hit that perfect finished size and the Chatter starts kicking in ???
What I find works for me when Chatter starts on Threads is just live with it until the final cuts where I come back with light finishing passes to clean up the Thread and remove the Chatter.
You were bound to get Chatter on a fairly thin wall material hanging out from the Chuck.
Nice work man 👍
Gordo amigo
Buena pieza fabricaste 👍
could you go into more detail about that thread? the second threading cycle.
It would appear that he roughed out a square thread to the major diameter (leaving stock on either side) and then ran at least 2 more cycles to finish each side of the thread without cutting on the tip of the tool, just puting a 30 degree angle on either side creating a 60 degree thread with a wide flat bottom as opposed to a standard thread with a point. cutting a thread on 3 sides of a tool is too much engagement for just one threading cycle in most cases. \_/ vs \/
Looks good Man