Great video thank you for posting. When you turn the Hi and Lo mixture screws in, do they contact a seat, or can you just turn the screw until it comes to a complete stop?
@@PowerRepublic thanks for the reply! Love the channel have learned tons. So, the carbs on his iame swift mini and mini rok have diaphragm type Tilotson. No float. Just like the one in this video.. where would be a good start for the high and low jets. Thanks again!!
I wish you made a long video on this explaining how to adjust it for different tracks
got one on tuning with a Lambda kit using Mychron, have you seen that one?
@@PowerRepublic no sir. Would you mind sharing the link? And thank you for the response. You are the best, learned so much from you
Love this content dezzy. You make life simple for us newbies
thanks for watching legend
Great video thank you for posting. When you turn the Hi and Lo mixture screws in, do they contact a seat, or can you just turn the screw until it comes to a complete stop?
Yeah close them off till they seat in the little holes
@powerrepublic what about settings on a tillotson mini rok and a mini swift. My son is cadet micro. Thanks
4mm float height like in the mini rock carb video we did a few years ago. 92-95 main jet, cli[p 2 or 3 mostly
@@PowerRepublic thanks for the reply! Love the channel have learned tons. So, the carbs on his iame swift mini and mini rok have diaphragm type Tilotson. No float. Just like the one in this video.. where would be a good start for the high and low jets. Thanks again!!
Awesome and Thankyou
Most welcome 😊
This is for X30! Tillitson carb for KA100 baselines at 1 turn and 1 turn!
correct, thanks for the tip
With which restrictor?
What about the throttle speed screw?
For idle ?? Just open it up so that the engine doesn’t stall , especially when you slam ya brakes on
I have a tillotson toledo HL304E, is it the same configuration for all tillotsons?
not sure, most are the same other than the pop pressure can change for each type of engine. what engine is it on ?
@@PowerRepublic komet k55
Is it the same for x30 senior as for x30 junior?
Not 100% cause we don't have them here in AUS. But if it is as I would imagine, richen the Low and Lean out the High
Is one turn open a full 360 revolution?
Yes it is. 60mins = 1 full turn open
I belive! & Know soo' by the Front of caburator'e by 🤝 Pipe Name: Durchmesser come in some fresh Air + by the 2 flow needl'les doo' the Setup.
Thanks 🙏 for watching the vid