Trick - How to make your own Sanding Belts
HTML-код
- Опубликовано: 10 мар 2021
- In the next video I will show you how to make Sanding Belts yourself, it is very simple, easy and strong you can also make it in any size you need and with the help of easy to obtain raw materials you will find them in every store.
1. Take the desired size of the belt and add another 2 cm along the general length and then cut.
2. Mark the 2 cm and start scraping the glass layer out of the paper until you reach the silk felt.
3. Clean dust and grease well and glue both ends of the strip with high-quality fast glue.
4. Wait long enough for the glue to dry completely and it is possible to start using the belt.
It is important! At the stage where you scrape the glass layer out of the paper it is very important to remove the entire glass layer until you reach the silk felt, otherwise the adhesion will not be strong enough.
In the video I used starbond quick glue
bit.ly/3qEWR96
Follow me and stay tuned:
Instagram / diyfixman
RUclips / diyfixman
Facebook / diyfixman
Pinterest / diyfixman
TikTok / diyfixman
Watch all my Videos bit.ly/2kHCZq0
Join the members club now on my channel
and get access to exclusive videos for club members!
/ diyfixman
No matter what language you speak, join our global Facebook group now.
There you can see DIY works of people from around the world!
Join now: / diyfixman
Thank you very much to all my RUclips followers. Thank you for your great support. You are the ones who motivate me to make interesting new videos for you. Without you it would not have happened! if you like my videos please let me know in the comments, like, share and follow me, your help is much appreciated. If you would like to support my videos feel free to like, share and subscribe, that helps me a lot. I wish everyone a pleasent and enjoyable viewing. 
Хобби
You might want to cut your sandpaper on a bit of diagonal.
Also, there are some aggressive adhesive tapes available that you might want to try for connecting your ends, by applying the tape to the back of your sanding belt material.
Thanks. Super Simple and Short. ! Sweet.
thank you ❤️
1. Joint is done in the wrong direction with respect to the belt arrow. 2. Adhesive used may likely harden and will likely break off during rotating. 3. A right angle joint will cause a sudden raise on the belt causing a bump when sanding. 4. Hand pressing the belt together to form the joint is going to cause a large raise. 5. This belt is of fine girt, such joint when used on rougher grit will not last at all. Likely break off during the first few runs.
I have this idea in mind but I'm short supply, thanks for validating it! Cheers!
Thank you very much my friend
Good, thanks for sharing. Usually, the the contact area/surface has the shape of triangle to avoid all the attachment points of the contact place to face the material at the same time.
You're absolutely right, I know that too. In small belts diagonal cutting is not significant but in wider and longer straps a goat diagonal connection should definitely be made to distribute the load on the connection.
How long the belt last without separating on a high speed sander? It's always Way more destructive to one than pulling with hands cause it is bent right at the seam thousands of times circulating around the pulleys
Cool idea mate 👍🤩🍻
Thank you so much my friend!
Werw do u buy the sanding belt on a roll like u have got there.
Glue type?
I used a very strong quick glue.
www.starbond.com/?rfsn=4557311.24979e
@@DIYFixMan CA ? Thanks
👍👍👍👍🤝
Why do you spoil your Videos with crap music, rather listen to the ambient noise?
🤷🏻♂️