Это видео недоступно.
Сожалеем об этом.
AFR Gauge Datalog with HPTuners
HTML-код
- Опубликовано: 19 дек 2020
- #hptuners #datalogging #tuning
HP Tuners is great software, and this is another reason why think so. You can connect a wideband O2 sensor to HPTuners via RS232 and read real time data a log it for tuning purposes.
Thanks For Watching!
For Merch head over to our store on teespring!
teespring.com/s...
Check out our our website here!
www.clevorbmf.com
Follow me on social media!
TikTok:
vm.tiktok.com/...
Facebook:
/ brooks.mf
Instagram:
/ fred_stang408
Snapchat:
/ fred_stang
My Website:
www.clevorbmf.com
Disclaimer:
Due to factors beyond the control of ClevorBMF, I cannot guarantee against improper use or unauthorized modifications of this information. ClevorBMF assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ClevorBMF recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ClevorBMF, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ClevorBMF.
Good work! Hoping to eventually get my ms3 up and running. Look forward to working with you🤘
so how did u configure your hystograms with the AEM unit
Do you actually need all those converters or can you just go and create a USB plug off of the ground and Signal wire?
You can try that. This is the only way I’ve been able to get it to work tho
@TurboDadGarage did you ever try to make or get a direct USB connector?
Damn ive tried every type of serial connector and just can not get my hptuners to see AFR. as soon as i start scanning the channel just disappears..
I’ve had that happen a lot too and I’m not sure why… the first time I did it was this video and it worked perfect… after that, I fight it every time
How did you build the AFR table ?
Built the afr table based of what areas of the tune I’ll be in wot, cruise, or idle
DOES THIS WORK WITH MPVI3
I’m not sure. Only tried it with mpvi2
Can you install the wideband after the cat converter?
Yeah, you can
I guess you can call every factory and let them know they shouldn’t install pre and post cat AFR sensors. Gtfo with that nonsense. If you ain’t got nothing constructive or helpful to say, move along. No one needs your negative ass bs in here.
💗
❤️❤️❤️
do i need all this if i get the pro features from hptuners?
Not necessarily, but if your car doesn’t have a wideband can be monitored from the ecu, then yes
@@BMF_Garage just to confirm, pro version is not needed to datalog the wideband as shown in your video? I just got the standard mpvi2 and I'll be going this route to read afr if it works. Thanks.
That’s correct