How to seal rear spoiler - Audi TT mk3
HTML-код
- Опубликовано: 4 сен 2024
- One veeery common issue among audi tt 8s drivers is water coming in the boot and damaging licence plate lights. This is how to properly make the rear wing watertight and prevent the floods :D
As always, very useful...am I the only one who hardly waits to see the final look of the yellow beauty? Keep moving forward 💪🧐
You're the best!
This was so much help, thanks. Now my boot is no longer full of water!
Wonderful! I am so glad the video helped 🤗🤗
Thank you for your video, I’ve been looking for this solution for a while now. My GF TT Roadster has had water trapped in the boot and her number plates lights were destroyed. Very expensive! The Audi Main Dealer solution was to replace the whole spoiler mechanism because a seal is not available, at a cost of €1500!!!
I was thinking of sealing the spoiler assy like you, but not sure where to start, very many thanks for the insight. ❤️👌
Omg.. that is so expensive! I saw that the spoiler seal is not separate part, but it is glued to spoiler.
Trust me this is your best solution 👍🏻👍🏻😎
@@audi_anatomy I know, all for the sake of a cheap seal. I’m just doing this one now, you are a star 💫. Thank you 🤩
@@LotusAir oh i am so happy the video helped!! 👍🏻👍🏻👍🏻 thank you!
Do I have an Audi? NO
Did I found this video useful and interesting? YES
hehhehe, thank you so much, that is an honest compliment! :D
If you ever wished to own one, I hope it comes soon!! :)
My Genie ❤
Hi mate, very useful video thanks a lot !
Do I need to disconnect the battery before doing this ?
Thank you so much!
I usually dont disconnect the battery unless working on airbags. So you should be good. :)
Hi if I glue spoiler will water still go into rear camera? Or do I have to glue both spoiler and rear camera?
The water usually comes through spoiler. But its not a bad idea to seal the camera as well. I have a video on that as well, check it out :)
@@audi_anatomy thank you for the info
Hi mate! I have a TTRS without the active wing. I have an aftermarket wing on the car and an issue with water getting in and ruining my plate lights and latch mechanism. Do I need to seal where you sealed or just the bolts that hold the wing onto that panel?
I would make sure to seal every point where water might be leaking in. So once around the perimiter of the spoilers, and around the screws as well :)
I have this problem also. Lifting the tailgate resulted in water flowing even through the seat belt entry points... taking it back to bodyshop where I got the wing installed tomorrow
@@challengeronrift oh my, that is aloot of water :(( i hoe they fix it. You can tell then to seal it like this. :)