The company philosophy at J-B Weld is not to provide the customer with any service but to tell them to "go pound sand"! You can't complain about the customer service at JB Weld, because there isn't any!!!!
Do you think this would be okay to use on my hull? I have a few spots that are about 2 1/2 inches long and about 1/8th of an inch wide, very small spots. I was thinking of putting this on my hull and then later going back and using a gel coat repair kit.
I’m thinking of spraying it into the corner of a ziplock bag, mixing it and cutting the tip off to make something like a caulk applicator.
The company philosophy at J-B Weld is not to provide the customer with any service but to tell them to "go pound sand"!
You can't complain about the customer service at JB Weld, because there isn't any!!!!
I think you can also sand it down after it dries
Thanks for sharing!
Do you think this would be okay to use on my hull? I have a few spots that are about 2 1/2 inches long and about 1/8th of an inch wide, very small spots. I was thinking of putting this on my hull and then later going back and using a gel coat repair kit.
great video
Thank you
Did it harden or did it stay rubbery?
How did it hold up I'm gonna use this to repair my rc boat