DELETE the EWS on your BMW WITHOUT USING BENCH SETUP!!!!

Поделиться
HTML-код
  • Опубликовано: 29 окт 2024

Комментарии • 11

  • @PSYgoaHEAD
    @PSYgoaHEAD 12 дней назад +1

    So there is no need to enter the bootmode with grounding a pin on the ecu?

  • @gruntygoat2622
    @gruntygoat2622 Месяц назад

    Is this possible to perform on a 2005 545i or 550i ? Please respond Also can you make a video of how make all the new modules put into the car work with the dme please help!!!!!

  • @MrGiannilee14
    @MrGiannilee14 Месяц назад

    Nice job liked the vid just recently my son's 03 e39 525i started melting cylinder 1 coil and check the wires all good ECU opened it up and had a small burn on a chip
    Do you suggest getting a used one flashed to my vin and bypass ews? Would like your help and knowledge $95 on eBay unless you sell them maybe I can by from you help needed .
    🙏

  • @PrinceHarry419
    @PrinceHarry419 8 месяцев назад

    Thanks so much for the vid. Worked perfectly for me👍🏾

  • @Ritcheyyy
    @Ritcheyyy 4 месяца назад

    What kind of cable do I need for this?

    • @SadnessRoblox
      @SadnessRoblox  2 месяца назад

      you need K9 cable

    • @eddyoviedo3062
      @eddyoviedo3062 Месяц назад

      ​@@SadnessRoblox will the BMW 1.4.0 scanner cable work for this?

  • @ogkaloo
    @ogkaloo 2 месяца назад

    I take the same steps and I remove my ews box and the car don’t start no crank nothing hmm

    • @SadnessRoblox
      @SadnessRoblox  2 месяца назад

      Did you scan using INPA? How did you arrive at EWS being the issue?

    • @PSYgoaHEAD
      @PSYgoaHEAD 12 дней назад

      The starter impuls goes via de ews i think... so you need to conect the two bigger wires that run to the ews ( i think)