Good day, Thank you for the comment. I am not 100% sure what you mean, but the assembly layout can not change from the way it was done here. In the question the basic layout was specified, so we must draw it the way the question asks. The component 1 cannot go in the other way as this will cause an interference between the wheel and part 1 due to the gap being 4mm on the one side and 11 on the other side. I hope I have answered your question here.
Can you send more lessons please miss
Ma'am
Can we not bring out the part 1 in the right side of the page if the nut is removed
Good day,
Thank you for the comment. I am not 100% sure what you mean, but the assembly layout can not change from the way it was done here. In the question the basic layout was specified, so we must draw it the way the question asks. The component 1 cannot go in the other way as this will cause an interference between the wheel and part 1 due to the gap being 4mm on the one side and 11 on the other side. I hope I have answered your question here.
@@riaanmeeser4755 Yes ma'am
My question is answered , thanks for the reply