2AR 2.5L Engine Balance Shaft Installation

Поделиться
HTML-код
  • Опубликовано: 24 янв 2025

Комментарии • 33

  • @sivucit
    @sivucit Год назад

    Thanks!

  • @moneymike2092
    @moneymike2092 6 месяцев назад +1

    How difficult is it to pull the engine cylinder block case from underneath car while it is still connected to the transmission? Need to do a rod bearing on piston 4 and is have low budget. Or is it much cheaper and easier to pull the engine out.

    • @MayoCarsDR
      @MayoCarsDR  6 месяцев назад

      To do a good job, you need to take the engine out and work it

  • @sivucit
    @sivucit Год назад +1

    After you put new engine, do you disable fuel and just crank car until oil light goes off. then after that you start car, or you just start the car without priming oil.

    • @MayoCarsDR
      @MayoCarsDR  Год назад

      Yes,
      This is correct step
      Disable fuel and just crank car unit oil light goes off

  • @andyg5004
    @andyg5004 3 месяца назад +1

    What should the setting be on TDC or set when all piston lined up

  • @denmarkcu1842
    @denmarkcu1842 4 месяца назад +1

    I have a 2011 Toyota Camry 2.5L that makes a rattling noise coming from what’s inside the oil pan when car is in idle with the A/C on. I’m assuming it’s my Balance Shaft. How difficult is it to remove and replace underneath the car with jack stands

    • @MayoCarsDR
      @MayoCarsDR  4 месяца назад

      Remove drive belt and check sound

    • @MayoCarsDR
      @MayoCarsDR  4 месяца назад

      I think it sound is ac compressor

  • @manuelramirez6688
    @manuelramirez6688 Год назад +2

    Saludos cordiales brother Caracas Venezuela 🇻🇪

  • @malikazharpac4076
    @malikazharpac4076 Год назад +1

    Hi dear. I have camry 2011 model manual. While driving when I accelerate in any gear at maximum speed. I feel ratling nosie from Engine RHS only driving on road. But when I lift up car. there's no sound.

    • @MayoCarsDR
      @MayoCarsDR  Год назад

      Where are you located
      You check drive belt tensioner and ac compressor
      Your car engine 2ar 2.5L ?

  • @sivucit
    @sivucit Год назад +1

    Thanks so much waiting for this vidoe. I cant thank enough. What is your name by the way.

    • @MayoCarsDR
      @MayoCarsDR  Год назад

      Thanks for comment and watching video

  • @ПавелКрасильников-ь9е

    Good work

  • @josedixiemedrano6123
    @josedixiemedrano6123 Год назад

    In what country this Toyota service center. Good... 👍

  • @ElijahRaphael-n8d
    @ElijahRaphael-n8d Год назад +1

    Very good, thanks

  • @michaelezekiel3852
    @michaelezekiel3852 Год назад

    Bro. Can you make video toyota landcruiser v8 gasoline engine rebuilding video in there global. Service manual procedure

  • @sivucit
    @sivucit Год назад

    Just donated 20 dollar.. Thanks and this is great help..

    • @MayoCarsDR
      @MayoCarsDR  Год назад

      Thanks for comment and watching video dear

    • @sivucit
      @sivucit Год назад

      @@MayoCarsDR HI i am planning to change all exhaust and intake valves in 2arfe engine. do i have to lap vlave.. if so how many time i should go while lapping like 6 to 9 time hand rotation..do u have video on this,

  • @HanifEFIMechanical
    @HanifEFIMechanical Год назад +1

    Good work

  • @AmjadYousaf-l2h
    @AmjadYousaf-l2h Год назад

    Good work