amazing, i don't know how can you control (to much speed)or see the rc car lol, i put lights to all my rcs, it helps me with the orientation of the RC.
@@dgitalchaos Cool, I just bought your system new for a really good price to install in my new Typhon V5, 21t Pinion going in so on 6s it should be sweet. Any ideas on what oils I should run to keep it from wheel standing unnecessarily ?
@@Top-Jimmy the stock oils should keep the Typhon from wheeling. The 1650kv motor will fit the mount, but it might not clear the body on the Typhon. Might have to do a little bit of modding to fit it.
@@carlosrubio7455 ah, I misunderstood. Usually people move the battery tray to fit a bigger motor. The Max 6 G2 fits on the ESC mount. I drilled 4 holes to match the mounting on the Max 6 G2, but people usually just use double sided RC tape.
I have a lot of people telling me the remote I have(which is the same as yours) needs to be upgraded for speed runs. What are your thoughts? They say the range is terrible.
I say test the range. I’ve been surprised by the distance of the stock radios. I find I usually hit top speed about 8 seconds into the run, so I adjust accordingly. I tried the RadioLink, but went out of range quicker than I thought and crashed my Felony 6S. Put the stock radio back and haven’t tried another brand. Plus the stock radio activates drag break when out of range instead of letting it coast to a stop like aftermarket radios.
@@grimyentertainment238 should certainly have the power. I was using stock motor timing, 6V on the BEC, stock punch settings. Center diff fluid was 200k. The only other thing I did was cut the wing to the lowest marks. Should take about 6 seconds for you to reach full throttle. Sooner than that will cause it to amp out.
I don’t have a Kagama, but it looks like it’ll fit as it has a similar setup as the Arrma 6S line. Not sure if the Kagama driveline could handle 8S without shredding the diffs. Again, I have zero experience with the Kagama.
@@kj4x4couple7 nice. That TP motor might make the Max 6 amp out quickly. I hear they draw a lot of power, but I’ve never tried a TP motor before so I don’t really know.
Nice run. But i have to ask, you said you were running the stock 46 spur and the tallest pinion it can fit. That is a 27T, not a 29T. Isn't that the one provided by Arrma in the box? (The one for speed runs). The sum of the teeth -by adding the teeth of the spur and pinion is 73 on the stock motor mount. It cannot be more than that. And even for the Arrmas using 50 spur, those can fit maximum a 23t pinion. And linitless (having a 39t spur, it fits a 34t pinion - or a 34t spur and 39t pinion). Anyway, very nice runs!
I got my Infraction used, but it fits the 29T a little tight. You have to pry the motor away slightly while tightening to get the mesh right. My Typhon 6S I bought new, and also fits the 29T pinion. I don’t know where I got the 29T pinion from. I think it was sitting in my RC parts box from at least 6 years ago.
@@nicozev8723 hmm, and yours is the V2? I suppose they could have made the mounts a bit different from batch to batch. My buddy has an infraction as well, I’ll see if the 29T fits his when I get a chance to check it.
@@dgitalchaos i have a felony, but the motor mount is the same on all arrmas. Right now i just tried, and it barely fits the 28t, and it's tight as hell (not usable). Maybe your motor mount is an after market one?
I won’t be recommending RadioLink to anyone. I tried the RadioLink RC6G3 V3 with the R7FG receiver and my range was 800 feet, which caused me to damage my Felony body. I sent RadioLink two emails and never received a reply. I returned the RadioLink and 5 receivers to Amazon for a refund. As for speed runs, I did manage to get 127MPH with the stock system. ruclips.net/video/87brIaic8jA/видео.htmlsi=icP0XABPpZZajQ6i
@@dgitalchaos well I’m not sure what’s going on with your radio link but we only speed run and are running 2000 to 3000 ft no issues H and w racing channel
@@dgitalchaosI had bad luck with the radiolink RC8X but doesn't even 3-400 feet at most on multiple different receivers and different antenna configurations.
![I.N "HALLUCINATION" | [Stray Kids : SKZ-PLAYER]](http://i.ytimg.com/vi/n5B5q1Hwt_U/mqdefault.jpg)
I’m running the same system in my infraction and love how smooth it is!!! AWESOME RUN!!! Happy RC’ing Y’all!!!
Thanks! Smooth for sure!
@3:46 & @6:08 for the speed runs.
Damn she moves well, so 11mph more with the 8S?
It went from 98MPH on 6S to 117MPH on 8S with the Max 6 combo. The 106MPH was with all stock electronics.
amazing, i don't know how can you control (to much speed)or see the rc car lol, i put lights to all my rcs, it helps me with the orientation of the RC.
I should add lights, that would help tremendously on speed runs.
Nice!! Is that the Ezyrun Combo with 160A ESC bro?
@@Top-Jimmy yes, that’s the previous generation of the Max 6 combo. The newest Max 6 G2 combo runs more efficiently.
@@dgitalchaos Cool, I just bought your system new for a really good price to install in my new Typhon V5, 21t Pinion going in so on 6s it should be sweet.
Any ideas on what oils I should run to keep it from wheel standing unnecessarily ?
@@Top-Jimmy the stock oils should keep the Typhon from wheeling. The 1650kv motor will fit the mount, but it might not clear the body on the Typhon. Might have to do a little bit of modding to fit it.
Hi could you pls put down the model/serial of the exact motor?
@@ahmersarwar I no longer have this combo. I now use the Max 6 G2 and the 4990 1650kv G2 combo and get 124mph.
Hola, has tenido que modificar caja de baterías para meter esc G2 ??? Gracias
No mods other than the Limitless motor mount and 56 series plate with the 5690 G2 motor. I don’t think the 1650kv motor needs a different mount.
No me refiero a soporte de motor. Me refiero al controlador esc 200A .
Le ha entrado sin problema ??
@@dgitalchaos
No me refiero a soporte de motor. Me gustaría saber si le ha entrado el ESC 200A sin problema ??
@@carlosrubio7455 ah, I misunderstood. Usually people move the battery tray to fit a bigger motor. The Max 6 G2 fits on the ESC mount. I drilled 4 holes to match the mounting on the Max 6 G2, but people usually just use double sided RC tape.
I have a lot of people telling me the remote I have(which is the same as yours) needs to be upgraded for speed runs. What are your thoughts? They say the range is terrible.
I say test the range. I’ve been surprised by the distance of the stock radios. I find I usually hit top speed about 8 seconds into the run, so I adjust accordingly. I tried the RadioLink, but went out of range quicker than I thought and crashed my Felony 6S. Put the stock radio back and haven’t tried another brand. Plus the stock radio activates drag break when out of range instead of letting it coast to a stop like aftermarket radios.
@@dgitalchaos are you using any special receivers?
@@Singuy888 just the stock receiver that comes in the Infraction 6S.
Why's everyone run such low kv motors? Higher kv less voltage is the way to go
How? I have the exact same set-up. Same tooth gears, same motor and esc combo and 8s, and my esc cut out at 83mph. What am I doing wrong?
Hmm, which batteries and connectors are you using?
@@dgitalchaos HOOVO 4s, 6200 Mah, 120c, EC5 plugs. So 2 of these for 8s.
@@grimyentertainment238 should certainly have the power. I was using stock motor timing, 6V on the BEC, stock punch settings. Center diff fluid was 200k. The only other thing I did was cut the wing to the lowest marks. Should take about 6 seconds for you to reach full throttle. Sooner than that will cause it to amp out.
Can I put this setup in the Kagama ??making it 8s?
I don’t have a Kagama, but it looks like it’ll fit as it has a similar setup as the Arrma 6S line. Not sure if the Kagama driveline could handle 8S without shredding the diffs. Again, I have zero experience with the Kagama.
Thanks for you advice, might just keep it the way it comes.
Is this the max6 g2?
No, this is the first Gen Max 6 and 1650kv motor. I’ve yet to do speed runs with the Max 6 G2.
I just got the new g2 1650kv motor and pair it with the max5 on 6s I ran 93 I can’t wait to hit over 100+ like you!!! Great pass brother
Thanks! 93 is fast! 8S will certainly get you over 100MPH! I think on 6S with the 1650, I got 98MPH, but don’t quite remember.
@@dgitalchaos hoping so!! I also have another set up is a tp 3650 2350kv with a max6 I’m hoping to break 100 on a 3s stretch typhon
@@kj4x4couple7 nice. That TP motor might make the Max 6 amp out quickly. I hear they draw a lot of power, but I’ve never tried a TP motor before so I don’t really know.
@@dgitalchaosyea I heard that too. But is only a 6s motor and the esc is a 8s capable so I’m hoping that I can do some good things out of it haha
@@kj4x4couple7 heck yeah!
You should stand on your tailgate. You could see better signal work better too.
@@ikeeiie78 it’s safer too.
@@dgitalchaos for sure !
Hi,
Will 8s broke the 1650kv motor?
Thank you
It handles 8S very well, but motor fan are a must. As long as the motor doesn’t get hotter than 165°F constantly, you should be good to go.
@@dgitalchaos thank you
Nice run. But i have to ask, you said you were running the stock 46 spur and the tallest pinion it can fit. That is a 27T, not a 29T. Isn't that the one provided by Arrma in the box? (The one for speed runs). The sum of the teeth -by adding the teeth of the spur and pinion is 73 on the stock motor mount. It cannot be more than that. And even for the Arrmas using 50 spur, those can fit maximum a 23t pinion. And linitless (having a 39t spur, it fits a 34t pinion - or a 34t spur and 39t pinion). Anyway, very nice runs!
I got my Infraction used, but it fits the 29T a little tight. You have to pry the motor away slightly while tightening to get the mesh right. My Typhon 6S I bought new, and also fits the 29T pinion. I don’t know where I got the 29T pinion from. I think it was sitting in my RC parts box from at least 6 years ago.
@@dgitalchaos thanks. That is super weird, i tried to fit a taller pinion (more than 27) and ..not a chance :))
@@nicozev8723 hmm, and yours is the V2? I suppose they could have made the mounts a bit different from batch to batch. My buddy has an infraction as well, I’ll see if the 29T fits his when I get a chance to check it.
@@dgitalchaos i have a felony, but the motor mount is the same on all arrmas. Right now i just tried, and it barely fits the 28t, and it's tight as hell (not usable). Maybe your motor mount is an after market one?
@@nicozev8723 it might be, but it’s the stock color. The Typhon I know is Arrma since I bought that one new.
Nice pass bud I’d invest in radio link as you get faster you will need range H and w racing channel
I won’t be recommending RadioLink to anyone. I tried the RadioLink RC6G3 V3 with the R7FG receiver and my range was 800 feet, which caused me to damage my Felony body. I sent RadioLink two emails and never received a reply. I returned the RadioLink and 5 receivers to Amazon for a refund.
As for speed runs, I did manage to get 127MPH with the stock system. ruclips.net/video/87brIaic8jA/видео.htmlsi=icP0XABPpZZajQ6i
@@dgitalchaos well I’m not sure what’s going on with your radio link but we only speed run and are running 2000 to 3000 ft no issues H and w racing channel
I bought an RC8X and that thing is such a hunk of crap. Terrible range and random signal losses and I'm not the only one who's had these same issues.
@@dgitalchaosI had bad luck with the radiolink RC8X but doesn't even 3-400 feet at most on multiple different receivers and different antenna configurations.
@@cd-pu5uv I was going to try that Radio, but since RadioLink customer service was so bad, decided against using them.