Nice video; thanks for sharing! Glad to hear about the 1/4” washers; it’s nice to have an alternative to buying the green inset pieces you were talking about 3D printing. I ended up making some hold-downs for this with 3 pieces of 3/8” by 3/4” ply (glued together, with a slot in the middle for the bolt), some 1/2” dowel at one end, and rubber furniture shims at the other. They work pretty well so far. Thanks again for the vid!
![Microjig Matchfit Dovetail Clamps 8 months on [video 520]](http://i.ytimg.com/vi/02Up8x6Zy00/mqdefault.jpg)
Nice video; thanks for sharing! Glad to hear about the 1/4” washers; it’s nice to have an alternative to buying the green inset pieces you were talking about 3D printing.
I ended up making some hold-downs for this with 3 pieces of 3/8” by 3/4” ply (glued together, with a slot in the middle for the bolt), some 1/2” dowel at one end, and rubber furniture shims at the other. They work pretty well so far. Thanks again for the vid!
That's a great idea for hold-downs! I'll have to give that a try!
Matchfit makes 1/4" collet dovetail bits as well. I've used one without a relief cut, but I probably won't do any more that way.
Good to know. A 1/4" bit would be nice in a trim router but I would be worried it would be under powered.