Hello my friend, the trick about wheel alignment front or back is to make sure all spokes are tight enough not too tight or too losse, All are have same tension, then start to align the wheel rim buy tighten the spokes on side of the wheel is leaning away, make sure never tight too much, thank you and all the best 🙏
Yes of course same rim can be use again, you can uninstall then install on same rim no problem at all uninstalling is mush easy than installing, thank you and all the best 👍 🙏
Use any spring such as from screen door, or old metal bed, or you can make your own spring, twist a piece of wire steel around screwdriver and heat it with touch than put it immediately in old engine car oil.
Hello my dear friend, it's not complicated but it's true, the sprocket must be very true in order to spin nice and easy , other wise it will spin rough and ride the bike will be so rough and it may end up loose the chain or damage, sometimes the 2 black rubber not even and must be sanded so when you tight them all together should be straight . Thank you and all the best
Whats the best advice that you can give when it comes to alignment of rhe rear sprocket... Im having a problem with that...
Hello my friend, the trick about wheel alignment front or back is to make sure all spokes are tight enough not too tight or too losse,
All are have same tension, then start to align the wheel rim buy tighten the spokes on side of the wheel is leaning away, make sure never tight too much, thank you and all the best 🙏
@donaldpeltier7855 tight all loose spokes then tight spoke where wheel rim is off or not straight opposite side
thank you for watching 👀 🙏
please support our Channel ❤️
do rear wheel bolts in a star tightening wont have all the problemes
No, they shouldn't, if the bolts are tight enough equally and all the locker washers so the bolt never loosen, thank you and all the best 🙏😊
Can you uninstall then reinstall on same rim
Yes of course same rim can be use again, you can uninstall then install on same rim no problem at all uninstalling is mush easy than installing, thank you and all the best 👍 🙏
What size socket for bolts
21 mm , deep bolts,
all the best my friend 😋
Does it matter which wheel it’s on
Most bicycle tires should fit except new bicycle with new hub wider ones ,
Thank you and all the best 🙏
👋👋👋👋👋
Thank you so much and all the best 🙏🙏🙏
I don't have spring
Use any spring such as from screen door, or old metal bed, or you can make your own spring, twist a piece of wire steel around screwdriver and heat it with touch than put it immediately in old engine car oil.
They made it soooo complicated. Installing a sprocket is not like this!
Hello my dear friend, it's not complicated but it's true, the sprocket must be very true in order to spin nice and easy , other wise it will spin rough and ride the bike will be so rough and it may end up loose the chain or damage, sometimes the 2 black rubber not even and must be sanded so when you tight them all together should be straight .
Thank you and all the best