Prusa XL Replace Docks

When I first got my printer the docks were a major pain to install. I decided to file them down a bit to make them fit and over did it. This caused issues with tool changes that would cause failed prints. Prusa just recently made the spare parts available and I ordered replacements. This is the video of those being installed and the calibration after the fact.

[@Rmilyard]

How did you get that screw out holding dock? Looking at like min 18 in video. I can't get mine out.

[@Arcadenut1]

The top part comes off. Skip to the 45 min mark and you should see what I removed.

[@Rmilyard]

@@Arcadenut1what size allen if remember?

[@Arcadenut1]

@@Rmilyardthey are M3, so a 2.5mm Allen for the center, and Torx for the upper and lower.