I have a c0298 P1120 Wire was damaged and replaced. I erased codes works fine. I turn off vehicle and the codes will appear again.. I erased codes again. Works perfectly. Turn off and back on again and codes reaper
Hello! I don’t remember how I found out about your channel, I think it appeared on RUclips in recommendations. I immediately realized that your research was excellent👍🏻,👏🏻. 👨🏼🔧⚡. And Subscribed to the channel☑️ Hello from 🇰🇿
First what a great video. Am here because I have an issue with mine..... I think. I have a code reader saying it's running lean on both banks. p0174 p0171 Could this be the result off a bad sensor? I've just changed the O2 sensor pre cat as that was an issue too.
Hi i have a frequent fault that pops up stopping me from starting my engine , it pops up randomly and takes a bit to clear , usually just turning off main power for a couple of minutes or cycle the key on / off / on a bunch of times will clear the displayed "service" and allow you to start. this can come and go when ever it pleases it states that ... if faults are recognised which affect the multifunction indicator , "service" is then displayed this is a marine diesel Audi 4.2 TDI with a multifunction dislay showing RPM , TEMP , HRS , FUEL USAGE , FUEL BURN. another interesting finding is this seems to occur more when engine has warmed up and its shut down and go to restart .........
If you were to measure the voltage between TPS1 and TPS2, would it not be constant around 0 volts and if there is an issue with one or both pots, would it show a large fluctation ?
had an issue of throttle body signal dash light, service cleaned it, (says not to) but worked for about a month, bought a new one and cleared light, so far no issues, but vehicle sat for about two weeks. started fine ran to store, came back to park it and truck wanted to accelerate, pushed brake pedal but could feel it wanted to move, engine started to rev up put it in park, and rpm's went to 4000 then came down, restarted many times and ran around about one mile and issue did not re-a cur. 2004 dodge Durango 5.7 ltr 4wheel limited. will a code be stored? and what might issue be? first time this has ever happened. thanks
Hi I have an insignia 2014 elite estate it has no power to fuses 37-38. Should this be powered or does it get power from an ECU. It has lin 1 and lin 2 to issue on headlight circuit and no main beam.if it needs an ECU test can you perform and let me know which ECU you would suspect.
Question for you, Renault Trafic 2017, since 2 days no start stop system, not able to read anything about dpf system, not able to read anything about battery system, engine use more fule and stinks when started, NOX reads 65555 ppm. NO faults when reading OBD2 with scanner ??? Car starts and drive normal. Garage has no answer....
What if the butterfly won’t open when you accelerate when the car switch is on and also when the car is fully on, but i idle correctly but rpms will only reach 4000 when you hit the gas, is the throttle body broken? Please help
Most likely I have exactly the same problem It only opens while idling for a brief moment when you press pedal to the metal? I’m going to the mechanic tomorrow
👍 PERCEPTIVE, ECU TESTING, TIM Carryout Voltage Drop testing Please ,Tim From Nick Ayivor from London England UK 🇬🇧 ⏰️ 22;42PM Good Evening Great news, England won tonight football game Now in the final on Sunday with spain
TOyota FJ cruiser. Vehicle wont start when intake is taken off and throttlebody is exposed. It simply wont run - shuts it-self down. 2007 V6 VVTI engine. my P0121 returned after a year - I doubt its a dirty TB again ... FUCK
🔎 Have you discovered you have a faulty throttle body or ECU? 🤯 Get it remanufactured here: link.ecutesting.com/ECUrepair
I have a c0298
P1120
Wire was damaged and replaced. I erased codes works fine. I turn off vehicle and the codes will appear again.. I erased codes again. Works perfectly. Turn off and back on again and codes reaper
As a keen home 'mechanic' I always learn a lot from your videos. Thanks for taking the time to put these together. 🔧
Thank you! We appreciate the kind words and are glad to hear you find the videos helpful!👍
this channel should have millions of followers. very well and informative thorough exploration. many thanks
Hello!
I don’t remember how I found out about your channel, I think it appeared on RUclips in recommendations.
I immediately realized that your research was excellent👍🏻,👏🏻.
👨🏼🔧⚡.
And Subscribed to the channel☑️
Hello from 🇰🇿
Thank you for the support! We're glad you came across our channel and found us useful!
Hi there, can you please make a video on how to really use diagnostic tool hundred percent?
Nice video and great information. Thanks for taking the time to produce those videos.
Thank you for the kind words!
Excellent work on this video! Graphics are great. This was the technical info that I was looking for.
the most precise and organized video
Very informative video, brother thanks
As always great information.
Can you make a video about oxygen sensor (lambda sensor for diesel cars ).
Thank you
Thank you for your valuable information, good luck.
Thank you so much!
Well done, very thorough.
🙌 I'm waiting to learn more from you. my teacher. good demonstration. Thank a lot 👍
Hi, thanks a lot for all the info, can I know what software did you use to do the explain videos?
people are lazy, this is a great channel keep it up!
Is there a video for P1124? Please and thank you!
First what a great video.
Am here because I have an issue with mine..... I think.
I have a code reader saying it's running lean on both banks. p0174 p0171
Could this be the result off a bad sensor?
I've just changed the O2 sensor pre cat as that was an issue too.
Nice and great work
Thank you!
Thanks your video channel was great awesome and very helpful informative ❤❤❤🙏🙏👍
Smart man thanks for sharing
Hi i have a frequent fault that pops up stopping me from starting my engine , it pops up randomly and takes a bit to clear , usually just turning off main power for a couple of minutes or cycle the key on / off / on a bunch of times will clear the displayed "service" and allow you to start. this can come and go when ever it pleases it states that ... if faults are recognised which affect the multifunction indicator , "service" is then displayed this is a marine diesel Audi 4.2 TDI with a multifunction dislay showing RPM , TEMP , HRS , FUEL USAGE , FUEL BURN. another interesting finding is this seems to occur more when engine has warmed up and its shut down and go to restart .........
If you were to measure the voltage between TPS1 and TPS2, would it not be constant around 0 volts and if there is an issue with one or both pots, would it show a large fluctation ?
Awesome vid
Hai bro can you plz tell how to check desel engin injector feed circuit
hello thank for video
Thank you for the support!
How would you test a 12 GMC ACADIA throttle position sensor and ECU?
had an issue of throttle body signal dash light, service cleaned it, (says not to) but worked for about a month, bought a new one and cleared light, so far no issues, but vehicle sat for about two weeks. started fine ran to store, came back to park it and truck wanted to accelerate, pushed brake pedal but could feel it wanted to move, engine started to rev up put it in park, and rpm's went to 4000 then came down, restarted many times and ran around about one mile and issue did not re-a cur. 2004 dodge Durango 5.7 ltr 4wheel limited. will a code be stored? and what might issue be? first time this has ever happened. thanks
i would like to see clutch master cylinder hall sensor thanks
Can a TPS be cleaned
Hi I have an insignia 2014 elite estate it has no power to fuses 37-38. Should this be powered or does it get power from an ECU. It has lin 1 and lin 2 to issue on headlight circuit and no main beam.if it needs an ECU test can you perform and let me know which ECU you would suspect.
Question for you, Renault Trafic 2017, since 2 days no start stop system, not able to read anything about dpf system, not able to read anything about battery system, engine use more fule and stinks when started, NOX reads 65555 ppm. NO faults when reading OBD2 with scanner ??? Car starts and drive normal. Garage has no answer....
What if the butterfly won’t open when you accelerate when the car switch is on and also when the car is fully on, but i idle correctly but rpms will only reach 4000 when you hit the gas, is the throttle body broken? Please help
Most likely
I have exactly the same problem
It only opens while idling for a brief moment when you press pedal to the metal?
I’m going to the mechanic tomorrow
Brilliant
Wow gorgeous
Hi where you are located?? I want to bring my car
I took my volvo s40 to garage and they said its the bad signal to the throat body any help be good
Hello any help my mazda cx5 raves just sent 2012
What is P1658
👍
PERCEPTIVE, ECU TESTING, TIM
Carryout Voltage Drop testing Please ,Tim
From Nick Ayivor from London England UK 🇬🇧 ⏰️ 22;42PM Good Evening
Great news, England won tonight football game
Now in the final on Sunday with spain
TPS sensor
Nice one subscribe
Is there anything Jason statham can’t do
No
Yeah,,,,,, stop believing his movie character hype, and realize he is a guy with little mans disease.
Sir how translate in hindi
Or 5v référence
Throttle got no bottle 🥴🥴🥴
TOyota FJ cruiser. Vehicle wont start when intake is taken off and throttlebody is exposed. It simply wont run - shuts it-self down. 2007 V6 VVTI engine. my P0121 returned after a year - I doubt its a dirty TB again ... FUCK
😊😊😊😊😊😊😊😊😊😊😊😊😊😊😊😊😊😊😊😊😊😊😊