Vibration Isolation in Drone Flight controller

This is a small clip showing the effect of vibration isolation/damping in Drones. I used slow response foam to isolate the flight controller from the motor vibration. Did some tuning of the foam size to get the best reaponse.
#drone #arduino #engineering #education #experiment #hardware #vibration #hobby #homemade

[@guruji243]

Thanks for this vid

[@lightinggaming5202]

Please give schematic diagram for last drone i want to make it but i have ardiuno nano others are making drone with uno but when i saw your video i loved it so please give us schematic diagram and programing tutorial please please ❤

[@dhruvdroids]

Please follow Joop Brookings' tutorial. It's very detailed. Circuit is also available. Uno and nano are exactly same in terms of pin connection

[@amitkumar6784]

Bro MPU ko double side tape se chipkao..and prototype pcb hai uske nit ko lgane ke bich me rubber daalo

[@dhruvdroids]

Bro MPU ke lia foam nahi chahiye, mujhe lagana pada becoz mpu hil raha tha socket me. But PCB ke niche slow response foam laga hua hai aur use precisely tune kia gaya hai vibration isolation ke lia

[@amitkumar6784]

@@dhruvdroids oh I understand 😁

[@NAKK786]

Sir Manali me udega kya???🤓

[@picture9222]

Bro aapne vibration isolation kaise kiya

[@dhruvdroids]

First, you start by visual inspection. Use some foam or soft rubber, silicon etc. Then increase throttle gradually. During this, you will see the sudden increase in vibration of the controller. It is preferred to have the resonance at lower throttle (below 1300 throttle). Reduce foam stiffness and rerun the test till the resonance occurs under 1300 throttle. Once you have achieved that, you can further plot the acceleration values on serial monitor and modify the foam stiffness according. For hobby related drones, I think the total acceleration should be below 0.1g

[@abhishek84215]

I am trying to make quadcopter using joop code. My drone is not flying it's fliping everytime. Can you please help me to fix this issue?

[@dhruvdroids]

Its difficult to give an exact solution. But does it flip immediately on flight or randomly during flight. It's possible that you MCU is getting reset. Try powering it directly from the battery.

[@dhruvdroids]

Also. If it flips immediately on power then ur props direction could be an issue

[@abhishek84215]

@@dhruvdroids i checked prop direction it's according to joop brokking video

[@abhishek84215]

@@dhruvdroids It flips immediately

[@dhruvdroids]

Prop n motor direction both need to be correct. For instance diagonal motors need to have same rotation sense