👉 Visit My 3D Printing Channel! www.youtube.com/@3DParts4U 👉 Visit My Speed Modeling Channel! www.youtube.com/@AllVisuals4USpeed 🤝 Get Commercial Access To My Catalog Of 3D Files! www.patreon.com/3DParts4U (Or Support Me)
The cap is in percent. Therefore on the small diameter it is less then on the bigger diameter and even bigger over the length. But this is fine if you want to compensate shrinkage.
👉 Visit My 3D Printing Channel! www.youtube.com/@3DParts4U
👉 Visit My Speed Modeling Channel! www.youtube.com/@AllVisuals4USpeed
🤝 Get Commercial Access To My Catalog Of 3D Files! www.patreon.com/3DParts4U (Or Support Me)
The cap is in percent. Therefore on the small diameter it is less then on the bigger diameter and even bigger over the length. But this is fine if you want to compensate shrinkage.
Thanks for clearing up! Seems logic.
It's not like an equal offset.
@@AllVisuals4U uniform means, the same amount in all direction. In this case the same percentage. This is how I would interpret it.
Thanks again!
Sweet !
👍